1 * I2C controller embedded in STMicroelectronics STM32 I2C platform
4 - compatible: Must be one of the following
7 - reg: Offset and length of the register set for the device
8 - interrupts: Must contain the interrupt id for I2C event and then the
9 interrupt id for I2C error.
10 - resets: Must contain the phandle to the reset controller.
11 - clocks: Must contain the input clock of the I2C instance.
12 - A pinctrl state named "default" must be defined to set pins in mode of
13 operation for I2C transfer
14 - #address-cells = <1>;
18 - clock-frequency: Desired I2C bus clock frequency in Hz. If not specified,
19 the default 100 kHz frequency will be used.
20 For STM32F4 SoC Standard-mode and Fast-mode are supported, possible values are
22 For STM32F7, STM32H7 and STM32MP1 SoCs, Standard-mode, Fast-mode and Fast-mode
23 Plus are supported, possible values are 100000, 400000 and 1000000.
24 - i2c-scl-rising-time-ns: I2C SCL Rising time for the board (default: 25)
25 For STM32F7, STM32H7 and STM32MP1 only.
26 - i2c-scl-falling-time-ns: I2C SCL Falling time for the board (default: 10)
27 For STM32F7, STM32H7 and STM32MP1 only.
28 I2C Timings are derived from these 2 values
29 - st,syscfg-fmp: Use to set Fast Mode Plus bit within SYSCFG when Fast Mode
30 Plus speed is selected by slave.
31 1st cell: phandle to syscfg
32 2nd cell: register offset within SYSCFG
33 3rd cell: register bitmask for FMP bit
34 For STM32F7, STM32H7 and STM32MP1 only.
39 compatible = "st,stm32f4-i2c";
42 reg = <0x40005400 0x400>;
46 clocks = <&rcc 0 149>;
47 pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
48 pinctrl-names = "default";
52 compatible = "st,stm32f7-i2c";
55 reg = <0x40005400 0x400>;
58 resets = <&rcc STM32F7_APB1_RESET(I2C1)>;
59 clocks = <&rcc 1 CLK_I2C1>;
60 pinctrl-0 = <&i2c1_sda_pin>, <&i2c1_scl_pin>;
61 pinctrl-names = "default";
62 st,syscfg-fmp = <&syscfg 0x4 0x1>;