config DEBUG_STACKOVERFLOW
bool "Check for stack overflows"
- depends on DEBUG_KERNEL && PPC64
+ depends on DEBUG_KERNEL
help
This option will cause messages to be printed if free stack space
drops below a certain limit.
config DEBUG_STACK_USAGE
bool "Stack utilization instrumentation"
- depends on DEBUG_KERNEL && PPC64
+ depends on DEBUG_KERNEL
help
Enables the display of the minimum amount of free stack which each
task has ever had available in the sysrq-T and sysrq-P debug output.
This option will slow down process creation somewhat.
+config DEBUG_PAGEALLOC
+ bool "Debug page memory allocations"
+ depends on DEBUG_KERNEL && !SOFTWARE_SUSPEND
+ help
+ Unmap pages from the kernel linear mapping after free_pages().
+ This results in a large slowdown, but helps to find certain types
+ of memory corruptions.
+
+
config HCALL_STATS
bool "Hypervisor call instrumentation"
depends on PPC_PSERIES && DEBUG_FS
config XMON
bool "Include xmon kernel debugger"
- depends on DEBUGGER && !PPC_ISERIES
+ depends on DEBUGGER
help
Include in-kernel hooks for the xmon kernel monitor/debugger.
Unless you are intending to debug the kernel, say N here.
xmon is normally disabled unless booted with 'xmon=on'.
Use 'xmon=off' to disable xmon init during runtime.
+config XMON_DISASSEMBLY
+ bool "Include disassembly support in xmon"
+ depends on XMON
+ default y
+ help
+ Include support for disassembling in xmon. You probably want
+ to say Y here, unless you're building for a memory-constrained
+ system.
+
config IRQSTACKS
bool "Use separate kernel stacks when processing interrupts"
depends on PPC64
config BOOTX_TEXT
bool "Support for early boot text console (BootX or OpenFirmware only)"
- depends PPC_OF && !PPC_ISERIES
+ depends PPC_OF
help
Say Y here to see progress messages from the boot firmware in text
mode. Requires either BootX or Open Firmware.
config SERIAL_TEXT_DEBUG
bool "Support for early boot texts over serial port"
- depends on 4xx || LOPEC || MV64X60 || PPLUS || PRPMC800 || \
- PPC_GEN550 || PPC_MPC52xx
+ depends on 4xx
config PPC_EARLY_DEBUG
bool "Early debugging (dangerous)"
Select this to enable early debugging for legacy iSeries. You need
to hit "Ctrl-x Ctrl-x" to see the messages on the console.
+config PPC_EARLY_DEBUG_PAS_REALMODE
+ bool "PA Semi real mode"
+ depends on PPC_PASEMI
+ help
+ Select this to enable early debugging for PA Semi.
+ Output will be on UART0.
+
+config PPC_EARLY_DEBUG_BEAT
+ bool "Beat HV Console"
+ depends on PPC_CELLEB
+ select PPC_UDBG_BEAT
+ help
+ Select this to enable early debugging for Celleb with Beat.
+
endchoice
endmenu