* @IEEE80211_CHANCTX_CHANGE_RADAR: radar detection flag changed
* @IEEE80211_CHANCTX_CHANGE_CHANNEL: switched to another operating channel,
* this is used only with channel switching with CSA
+ * @IEEE80211_CHANCTX_CHANGE_MIN_WIDTH: The min required channel width changed
*/
enum ieee80211_chanctx_change {
IEEE80211_CHANCTX_CHANGE_WIDTH = BIT(0),
IEEE80211_CHANCTX_CHANGE_RX_CHAINS = BIT(1),
IEEE80211_CHANCTX_CHANGE_RADAR = BIT(2),
IEEE80211_CHANCTX_CHANGE_CHANNEL = BIT(3),
+ IEEE80211_CHANCTX_CHANGE_MIN_WIDTH = BIT(4),
};
/**
* that contains it is visible in mac80211 only.
*
* @def: the channel definition
+ * @min_def: the minimum channel definition currently required.
* @rx_chains_static: The number of RX chains that must always be
* active on the channel to receive MIMO transmissions
* @rx_chains_dynamic: The number of RX chains that must be enabled
*/
struct ieee80211_chanctx_conf {
struct cfg80211_chan_def def;
+ struct cfg80211_chan_def min_def;
u8 rx_chains_static, rx_chains_dynamic;
}
/**
+ * wdev_to_ieee80211_vif - return a vif struct from a wdev
+ * @wdev: the wdev to get the vif for
+ *
+ * This can be used by mac80211 drivers with direct cfg80211 APIs
+ * (like the vendor commands) that get a wdev.
+ *
+ * Note that this function may return %NULL if the given wdev isn't
+ * associated with a vif that the driver knows about (e.g. monitor
+ * or AP_VLAN interfaces.)
+ */
+struct ieee80211_vif *wdev_to_ieee80211_vif(struct wireless_dev *wdev);
+
+/**
* enum ieee80211_key_flags - key flags
*
* These flags are used for communication about keys between the driver
};
/**
+ * struct ieee80211_cipher_scheme - cipher scheme
+ *
+ * This structure contains a cipher scheme information defining
+ * the secure packet crypto handling.
+ *
+ * @cipher: a cipher suite selector
+ * @iftype: a cipher iftype bit mask indicating an allowed cipher usage
+ * @hdr_len: a length of a security header used the cipher
+ * @pn_len: a length of a packet number in the security header
+ * @pn_off: an offset of pn from the beginning of the security header
+ * @key_idx_off: an offset of key index byte in the security header
+ * @key_idx_mask: a bit mask of key_idx bits
+ * @key_idx_shift: a bit shift needed to get key_idx
+ * key_idx value calculation:
+ * (sec_header_base[key_idx_off] & key_idx_mask) >> key_idx_shift
+ * @mic_len: a mic length in bytes
+ */
+struct ieee80211_cipher_scheme {
+ u32 cipher;
+ u16 iftype;
+ u8 hdr_len;
+ u8 pn_len;
+ u8 pn_off;
+ u8 key_idx_off;
+ u8 key_idx_mask;
+ u8 key_idx_shift;
+ u8 mic_len;
+};
+
+/**
* enum set_key_cmd - key command
*
* Used with the set_key() callback in &struct ieee80211_ops, this
* @extra_tx_headroom: headroom to reserve in each transmit skb
* for use by the driver (e.g. for transmit headers.)
*
- * @channel_change_time: time (in microseconds) it takes to change channels.
+ * @extra_beacon_tailroom: tailroom to reserve in each beacon tx skb.
+ * Can be used by drivers to add extra IEs.
*
* @max_signal: Maximum value for signal (rssi) in RX information, used
* only when @IEEE80211_HW_SIGNAL_UNSPEC or @IEEE80211_HW_SIGNAL_DB
* @uapsd_max_sp_len: maximum number of total buffered frames the WMM AP may
* deliver to a WMM STA during any Service Period triggered by the WMM STA.
* Use IEEE80211_WMM_IE_STA_QOSINFO_SP_* for correct values.
+ *
+ * @n_cipher_schemes: a size of an array of cipher schemes definitions.
+ * @cipher_schemes: a pointer to an array of cipher scheme definitions
+ * supported by HW.
*/
struct ieee80211_hw {
struct ieee80211_conf conf;
void *priv;
u32 flags;
unsigned int extra_tx_headroom;
- int channel_change_time;
+ unsigned int extra_beacon_tailroom;
int vif_data_size;
int sta_data_size;
int chanctx_data_size;
netdev_features_t netdev_features;
u8 uapsd_queues;
u8 uapsd_max_sp_len;
+ u8 n_cipher_schemes;
+ const struct ieee80211_cipher_scheme *cipher_schemes;
};
/**
* appropriately (only the last frame may have %IEEE80211_TX_STATUS_EOSP)
* and also take care of the EOSP and MORE_DATA bits in the frame.
* The driver may also use ieee80211_sta_eosp() in this case.
+ *
+ * Note that if the driver ever buffers frames other than QoS-data
+ * frames, it must take care to never send a non-QoS-data frame as
+ * the last frame in a service period, adding a QoS-nulldata frame
+ * after a non-QoS-data frame if needed.
*/
/**
* See the section "Frame filtering" for more information.
* This callback must be implemented and can sleep.
*
- * @set_multicast_list: Configure the device's interface specific RX multicast
- * filter. This callback is optional. This callback must be atomic.
- *
* @set_tim: Set TIM bit. mac80211 calls this function when a TIM bit
* must be set or cleared for a given STA. Must be atomic.
*
* AP, IBSS/WDS/mesh peer etc. This callback can sleep.
*
* @sta_remove: Notifies low level driver about removal of an associated
- * station, AP, IBSS/WDS/mesh peer etc. This callback can sleep.
+ * station, AP, IBSS/WDS/mesh peer etc. Note that after the callback
+ * returns it isn't safe to use the pointer, not even RCU protected;
+ * no RCU grace period is guaranteed between returning here and freeing
+ * the station. See @sta_pre_rcu_remove if needed.
+ * This callback can sleep.
*
* @sta_add_debugfs: Drivers can use this callback to add debugfs files
* when a station is added to mac80211's station list. This callback
* station (which can be the AP, a client, IBSS/WDS/mesh peer etc.)
* This callback is mutually exclusive with @sta_add/@sta_remove.
* It must not fail for down transitions but may fail for transitions
- * up the list of states.
+ * up the list of states. Also note that after the callback returns it
+ * isn't safe to use the pointer, not even RCU protected - no RCU grace
+ * period is guaranteed between returning here and freeing the station.
+ * See @sta_pre_rcu_remove if needed.
+ * The callback can sleep.
+ *
+ * @sta_pre_rcu_remove: Notify driver about station removal before RCU
+ * synchronisation. This is useful if a driver needs to have station
+ * pointers protected using RCU, it can then use this call to clear
+ * the pointers instead of waiting for an RCU grace period to elapse
+ * in @sta_state.
* The callback can sleep.
*
* @sta_rc_update: Notifies the driver of changes to the bitrates that can be
unsigned int changed_flags,
unsigned int *total_flags,
u64 multicast);
- void (*set_multicast_list)(struct ieee80211_hw *hw,
- struct ieee80211_vif *vif, bool allmulti,
- struct netdev_hw_addr_list *mc_list);
-
int (*set_tim)(struct ieee80211_hw *hw, struct ieee80211_sta *sta,
bool set);
int (*set_key)(struct ieee80211_hw *hw, enum set_key_cmd cmd,
struct ieee80211_sta *sta,
enum ieee80211_sta_state old_state,
enum ieee80211_sta_state new_state);
+ void (*sta_pre_rcu_remove)(struct ieee80211_hw *hw,
+ struct ieee80211_vif *vif,
+ struct ieee80211_sta *sta);
void (*sta_rc_update)(struct ieee80211_hw *hw,
struct ieee80211_vif *vif,
struct ieee80211_sta *sta,
struct ieee80211_vif *vif, struct sk_buff *skb,
int band, struct ieee80211_sta **sta);
+/**
+ * struct ieee80211_noa_data - holds temporary data for tracking P2P NoA state
+ *
+ * @next_tsf: TSF timestamp of the next absent state change
+ * @has_next_tsf: next absent state change event pending
+ *
+ * @absent: descriptor bitmask, set if GO is currently absent
+ *
+ * private:
+ *
+ * @count: count fields from the NoA descriptors
+ * @desc: adjusted data from the NoA
+ */
+struct ieee80211_noa_data {
+ u32 next_tsf;
+ bool has_next_tsf;
+
+ u8 absent;
+
+ u8 count[IEEE80211_P2P_NOA_DESC_MAX];
+ struct {
+ u32 start;
+ u32 duration;
+ u32 interval;
+ } desc[IEEE80211_P2P_NOA_DESC_MAX];
+};
+
+/**
+ * ieee80211_parse_p2p_noa - initialize NoA tracking data from P2P IE
+ *
+ * @attr: P2P NoA IE
+ * @data: NoA tracking data
+ * @tsf: current TSF timestamp
+ *
+ * Return: number of successfully parsed descriptors
+ */
+int ieee80211_parse_p2p_noa(const struct ieee80211_p2p_noa_attr *attr,
+ struct ieee80211_noa_data *data, u32 tsf);
+
+/**
+ * ieee80211_update_p2p_noa - get next pending P2P GO absent state change
+ *
+ * @data: NoA tracking data
+ * @tsf: current TSF timestamp
+ */
+void ieee80211_update_p2p_noa(struct ieee80211_noa_data *data, u32 tsf);
+
#endif /* MAC80211_H */
OSDN Git Service
