p2p_connect <peer device address> <pbc|pin|PIN#> [display|keypad]
[persistent|persistent=<network id>] [join|auth]
- [go_intent=<0..15>] [freq=<in MHz>] [provdisc]
+ [go_intent=<0..15>] [freq=<in MHz>] [ht40] [provdisc]
Start P2P group formation with a discovered P2P peer. This includes
optional group owner negotiation, group interface setup, provisioning,
P2P implementations that require this to allow the user to accept the
connection.
-p2p_group_add [persistent|persistent=<network id>] [freq=<freq in MHz>]
+p2p_group_add [persistent|persistent=<network id>] [freq=<freq in MHz>] [ht40]
Set up a P2P group owner manually (i.e., without group owner
negotiation with a specific peer). This is also known as autonomous
Invitation
p2p_invite [persistent=<network id>|group=<group ifname>] [peer=address]
- [go_dev_addr=address]
+ [go_dev_addr=address] [freq=<freq in MHz>] [ht40]
Invite a peer to join a group (e.g., group=wlan1) or to reinvoke a
persistent group (e.g., persistent=4). If the peer device is the GO of
used to specify which device to invite. go_dev_addr parameter can be
used to override the GO device address for Invitation Request should
it be not known for some reason (this should not be needed in most
-cases).
+cases). When reinvoking a persistent group, the GO device can specify
+the frequency for the group with the freq parameter.
Group Operations