linux-user: Fix 'semop()' and 'semtimedop()' implementation

linux-user: Fix 'semop()' and 'semtimedop()' implementation

The implementations of syscalls 'semop()' and 'semtimedop()' in
file 'syscall.c' use function 'target_to_host_sembuf()' to convert
values of 'struct sembuf' from host to target. However, before this
conversion it should be check whether the number of semaphore operations
'nsops' is not bigger than maximum allowed semaphor operations per
syscall: 'SEMOPM'. In these cases, errno 'E2BIG' ("Arg list too long")
should be set. But the implementation will set errno 'EFAULT' ("Bad address")
in this case since the conversion from target to host in this case fails.

This was confirmed with the LTP test for 'semop()' ('ipc/semop/semop02') in
test case where 'nsops' is greater than SEMOPM with unaproppriate errno EFAULT:

semop02.c:130: FAIL: semop failed unexpectedly; expected: E2BIG: EFAULT (14)

This patch changes this by adding a check whether 'nsops' is bigger than
'SEMOPM' before the conversion function 'target_to_host_sembuf()' is called.
After the changes from this patch, the test works fine along with the other
LTP testcases for 'semop()'):

semop02.c:126: PASS: semop failed as expected: E2BIG (7)

Implementation notes:

    A target value ('TARGET_SEMOPM') was added for 'SEMOPM' as to be sure
    in case the value is not available for some targets.

Signed-off-by: Filip Bozuta <Filip.Bozuta@syrmia.com>
Reviewed-by: Laurent Vivier <laurent@vivier.eu>
Message-Id: <20200818180722.45089-1-Filip.Bozuta@syrmia.com>
Signed-off-by: Laurent Vivier <laurent@vivier.eu>