OSDN Git Service

net: dsa: realtek: fix Kconfig to assure consistent driver linkage
authorAlvin Šipraga <alsi@bang-olufsen.dk>
Tue, 12 Apr 2022 15:55:27 +0000 (17:55 +0200)
committerDavid S. Miller <davem@davemloft.net>
Wed, 13 Apr 2022 13:30:31 +0000 (14:30 +0100)
commit2511e0c87786f333c4665508f421ac99e378c719
tree1517a45f1edfec70403de1684ac2062a0b7b25e3
parentdad32cfeed7c5a375335b04398bf064a9c61cc20
net: dsa: realtek: fix Kconfig to assure consistent driver linkage

The kernel test robot reported a build failure:

or1k-linux-ld: drivers/net/dsa/realtek/realtek-smi.o:(.rodata+0x16c): undefined reference to `rtl8366rb_variant'

... with the following build configuration:

CONFIG_NET_DSA_REALTEK=y
CONFIG_NET_DSA_REALTEK_SMI=y
CONFIG_NET_DSA_REALTEK_RTL8365MB=y
CONFIG_NET_DSA_REALTEK_RTL8366RB=m

The problem here is that the realtek-smi interface driver gets built-in,
while the rtl8366rb switch subdriver gets built as a module, hence the
symbol rtl8366rb_variant is not reachable when defining the OF device
table in the interface driver.

The Kconfig dependencies don't help in this scenario because they just
say that the subdriver(s) depend on at least one interface driver. In
fact, the subdrivers don't depend on the interface drivers at all, and
can even be built even in their absence. Somewhat strangely, the
interface drivers can also be built in the absence of any subdriver,
BUT, if a subdriver IS enabled, then it must be reachable according to
the linkage of the interface driver: effectively what the IS_REACHABLE()
macro achieves. If it is not reachable, the above kind of linker error
will be observed.

Rather than papering over the above build error by simply using
IS_REACHABLE(), we can do a little better and admit that it is actually
the interface drivers that have a dependency on the subdrivers. So this
patch does exactly that. Specifically, we ensure that:

1. The interface drivers' Kconfig symbols must have a value no greater
   than the value of any subdriver Kconfig symbols.

2. The subdrivers should by default enable both interface drivers, since
   most users probably want at least one of them; those interface
   drivers can be explicitly disabled however.

What this doesn't do is prevent a user from building only a subdriver,
without any interface driver. To that end, add an additional line of
help in the menu to guide users in the right direction.

Link: https://lore.kernel.org/all/202204110757.XIafvVnj-lkp@intel.com/
Reported-by: kernel test robot <lkp@intel.com>
Fixes: aac94001067d ("net: dsa: realtek: add new mdio interface for drivers")
Signed-off-by: Alvin Šipraga <alsi@bang-olufsen.dk>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/dsa/realtek/Kconfig