OSDN Git Service
tracing: remove CALLER_ADDR2 from wakeup tracer
Maneesh Soni was getting a crash when running the wakeup tracer.
We debugged it down to the recording of the function with the
CALLER_ADDR2 macro. This is used to get the location of the caller
to schedule.
But the problem comes when schedule is called by assmebly. In the case
that Maneesh had, retint_careful would call schedule. But retint_careful
does not set up a proper frame pointer. CALLER_ADDR2 is defined as
__builtin_return_address(2). This produces the following assembly in
the wakeup tracer code.
mov 0x0(%rbp),%rcx <--- get the frame pointer of the caller
mov %r14d,%r8d
mov 0xf2de8e(%rip),%rdi
mov 0x8(%rcx),%rsi <-- this is __builtin_return_address(1)
mov 0x28(%rdi,%rax,8),%rbx
mov (%rcx),%rax <-- get the frame pointer of the caller's caller
mov %r12,%rcx
mov 0x8(%rax),%rdx <-- this is __builtin_return_address(2)
At the reading of 0x8(%rax) Maneesh's machine would take a fault.
The reason is that retint_careful did not set up the return address
and the content of %rax here was zero.
To verify this, I sent Maneesh a patch to create a frame pointer
in retint_careful. He ran the test again but this time he would take
the same type of fault from sysret_careful. The retint_careful was no
longer an issue, but there are other callers that still have issues.
Instead of adding frame pointers for all callers to schedule (in possibly
all archs), it is much safer to simply not use CALLER_ADDR2. This
loses out on knowing what called schedule, but the function tracer
will help there if needed.
Reported-by: Maneesh Soni <maneesh@in.ibm.com>
Signed-off-by: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>