OSDN Git Service
KVM: arm/arm64: Fix potential loss of ptimer interrupts
kvm_timer_update_state() is called when changing the phys timer
configuration registers, either via vcpu reset, as a result of a trap
from the guest, or when userspace programs the registers.
phys_timer_emulate() is in turn called by kvm_timer_update_state() to
either cancel an existing software timer, or program a new software
timer, to emulate the behavior of a real phys timer, based on the change
in configuration registers.
Unfortunately, the interaction between these two functions left a small
race; if the conceptual emulated phys timer should actually fire, but
the soft timer hasn't executed its callback yet, we cancel the timer in
phys_timer_emulate without injecting an irq. This only happens if the
check in kvm_timer_update_state is called before the timer should fire,
which is relatively unlikely, but possible.
The solution is to update the state of the phys timer after calling
phys_timer_emulate, which will pick up the pending timer state and
update the interrupt value.
Note that this leaves the opportunity of raising the interrupt twice,
once in the just-programmed soft timer, and once in
kvm_timer_update_state. Since this always happens synchronously with
the VCPU execution, there is no harm in this, and the guest ever only
sees a single timer interrupt.
Cc: Stable <stable@vger.kernel.org> # 4.15+
Signed-off-by: Christoffer Dall <christoffer.dall@arm.com>
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>