OSDN Git Service
Merge tag 'renesas-dt2-for-v4.14' of https://git./linux/kernel/git/horms/renesas into next/dt
Pull "Second Round of Renesas ARM Based SoC DT Updates for v4.14" from Simon Horman:
* Use newly added Gen-3 fallback compat string
This is consistent with ongoing efforts to use per-generation
fallback strings where appropriate across devices found
on R-Car SoCs. The aim of the effort being to strike a balance
between the limited information available about the compatibility
of devices found on different SoCs and the desire to ease enabling
devices on new SoCs.
This has no run-time effect due to the presence of a per-SoC
compat string.
* Enable second CPU core on RZ/G1M (r8a7743)
The RZ/G1M has two CA15 cores running at up to 1.5GHz
* Enable frequency scaling on RZ/G1M (r8a7743)
* Add six I2C cores to RZ/G1M (r8a7743) SoC DT
This is a step towards enabling these cores on boards that use this SoC
* Add CEC clock for HDMI transmitter to R-Car M2-W (r8a7791) Koelsch
Hans Verkuil says "The adv7511 on the Koelsch board has a 12 MHz fixed
clock for the CEC block. Specify this in the dts to enable CEC support."
* Add PFC support to RZ/G1E (r8a7745) SoC and add Ethernet and SCIF2
pins to SK-RZG1E board.
This allows the kernel to control multiplexed pins for Ethernet
and SCIF2 rather than relying on setup inherited at boot.
* tag 'renesas-dt2-for-v4.14' of https://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas:
ARM: dts: r8a7791: Use R-Car SATA Gen2 fallback compat string
ARM: dts: r8a7790: Use R-Car SATA Gen2 fallback compat string
ARM: dts: r8a7743: Add OPP table for frequency scaling
ARM: dts: r8a7743: Add APMU node and second CPU core
ARM: dts: koelsch: Add CEC clock for HDMI transmitter
ARM: dts: sk-rzg1e: add Ether pins
ARM: dts: sk-rzg1e: add SCIF2 pins
ARM: dts: r8a7745: add PFC support
ARM: dts: r8a7743: Add I2C DT support