OSDN Git Service
run-command: handle short writes and EINTR in die_child
If start_command fails after forking and before exec finishes, there
is not much use in noticing an I/O error on top of that.
finish_command will notice that the child exited with nonzero status
anyway. So as noted in v1.7.0.3~20^2 (run-command.c: fix build
warnings on Ubuntu, 2010-01-30) and v1.7.5-rc0~29^2 (2011-03-16), it
is safe to ignore errors from write in this codepath.
Even so, the result from write contains useful information: it tells
us if the write was cancelled by a signal (EINTR) or was only
partially completed (e.g., when writing to an almost-full pipe).
Let's use write_in_full to loop until the desired number of bytes have
been written (still ignoring errors if that fails).
As a happy side effect, the assignment to a dummy variable to appease
gcc -D_FORTIFY_SOURCE is no longer needed. xwrite and write_in_full
check the return value from write(2).
Noticed with gcc -Wunused-but-set-variable.
Signed-off-by: Jonathan Nieder <jrnieder@gmail.com>
Signed-off-by: Junio C Hamano <gitster@pobox.com>