OSDN Git Service
fs: fix nobh error handling
nobh mode error handling is not just pretty slack, it's wrong.
One cannot zero out the whole page to ensure new blocks are zeroed, because
it just brings the whole page "uptodate" with zeroes even if that may not
be the correct uptodate data. Also, other parts of the page may already
contain dirty data which would get lost by zeroing it out. Thirdly, the
writeback of zeroes to the new blocks will also erase existing blocks. All
these conditions are pagecache and/or filesystem corruption.
The problem comes about because we didn't keep track of which buffers
actually are new or old. However it is not enough just to keep only this
state, because at the point we start dirtying parts of the page (new
blocks, with zeroes), the handling of IO errors becomes impossible without
buffers because the page may only be partially uptodate, in which case the
page flags allone cannot capture the state of the parts of the page.
So allocate all buffers for the page upfront, but leave them unattached so
that they don't pick up any other references and can be freed when we're
done. If the error path is hit, then zero the new buffers as the regular
buffer path does, then attach the buffers to the page so that it can
actually be written out correctly and be subject to the normal IO error
handling paths.
As an upshot, we save 1K of kernel stack on ia64 or powerpc 64K page
systems.
Signed-off-by: Nick Piggin <npiggin@suse.de>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>