mtd: rawnand: qcom: set BAM mode only if not set already
BAM is DMA controller on QCOM ipq platforms, BAM mode on NAND driver
is set by writing BAM_MODE_EN bit on NAND_CTRL register.
NAND_CTRL is an operational register and in BAM mode operational
registers are read only.
So, before enabling BAM mode by writing the NAND_CTRL register, check
if BAM mode was already enabled by the bootloader, and enable BAM mode
only if it is not enabled already.
Signed-off-by: Sivaprakash Murugesan <sivaprak@codeaurora.org>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/linux-mtd/1591948696-16015-3-git-send-email-sivaprak@codeaurora.org
OSDN Git Service
