phy/rockchip: inno-hdmi: add more supported pre-pll rates

phy/rockchip: inno-hdmi: add more supported pre-pll rates

This adds a bunch of new pixel clock- and tmds rates to the pre-pll
table which are required to get more VESA and some DMT rates working.

It has been completely re-calculated to match the min- and max-vco of
(750 MHz - 3.2 GHz) requirements. If more than one configuration would
have been possible the lowest fbdiv and refdiv (and therefore lowest
vco rate) has been preferred.

It's important to note, that RK3228 version of the phy does not support
fractional dividers. To support the most possible rates for this version
also in both 8-bit and 10-bit variant, some rates are not exact. The
maximum deviation of the pixel clock is 0.26, which perfectly fits into
VESA DMT recommendation of 0.5%.

I tested all possible rates on several screens from different
manufacturers with both RK3228 and RK3328. Both pre- and post-PLL
locking are slighlty faster now.

Signed-off-by: Alex Bee <knaerzche@gmail.com>
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Link: https://lore.kernel.org/r/20230615171005.2251032-7-jonas@kwiboo.se
Signed-off-by: Vinod Koul <vkoul@kernel.org>