OSDN Git Service
greybus: platform: Add platform driver for DB3 AP bridge
With DB3, we now have AP as a master as far as AP bridges are concerned.
SVC will talk only to AP and AP will control bridges; unlike other
module interfaces.
So AP supposed to manage/control bridges in all power states including
power on reset.
During power on reset AP should follow below sequence -
Sequence (treated as a Cold Boot)
Stage-1
=======
AP:
- Power On (Power up from PMIC to AP)
- AP start booting
Since power to AP bridges are controlled through gpio, power is gated
to APB1 & 2
No ref_clk to APB available (under SVC's control)
- AP configures USB hub to enable HSIC interface to APB
- As part of platform driver probe, AP follow below sequence
- Set the pinctrl in default state
- Hold APBs in reset by pulling down reset pin
- Enable power to APB by enabling regulator and switches
- De-assert (set 'low') 'boot_ret' signal
- AP will assert (set 'high') the wake_detect signal, triggering
connect/detect event to the SVC
- AP waits for wake pulse from SVC
SVC:
- Power On (power up from PMIC to SVC)
- SVC starts booting
- SVC will de-assert reset signal to unipro switch
- Switch starts booting
- SVC confirms switch boot status using SPI (or something)
- SVC waits for 300 msec (ES2 known issue)
- SVC waits for detect/connect event from AP
Stage-2
=======
SVC:
- ON connect/detect event, SVC send back wake pulse (cold boot)
to AP over wake_detect pin, if SVC boot is completed.
AP:
- On wake pulse from SVC (for cold boot), AP de-asserts (set high')
reset signal to APB 1 and/or 2
- Bridges starts booting
- Eventually Unipro linkup occurs
Testing:
- Build tested against Helium kernel
- Due to unavailability of MSM and DB3 platform, only minimal testing
has been done.
- Code has been modified for validation on Helium + SDB platform.
Mostly dts changes for gpio numbers
And debug messages to check gpio values
- On Helium + SDB platform, with addition of debug messages validated
the sequence.
TODO list:
- Currently _only_ supports power on sequence (cold boot).
Both warm and cold boot support. Cold and Warm boot is
differentiated based on pulse width of wake_detect signal
>=5 msec = Cold boot else Warm boot
- No support for Power management
So the "power-down", "power-off", "wake_in" and "wake_out"
signals are not explored/implemented.
- Support for Work thread
repetitive wake signal if no response from peer
May required for PM support, as we have delays in the sequences
- pinctrl states, specially to make sure we enable right pullup or pulldown
when we set wake_detect pin to input
- Convert gpio list into an array, and associated xxx-gpio-name property
Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath@linaro.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@google.com>