#define EN0_CRDAHI 0x09 /* high byte, current remote dma address RD */
#define EN0_RSARHI 0x09 /* Remote start address reg 1 */
#define EN0_RCNTLO 0x0a /* Remote byte count reg WR */
+#define EN0_RTL8029ID0 0x0a /* Realtek ID byte #1 RD */
#define EN0_RCNTHI 0x0b /* Remote byte count reg WR */
+#define EN0_RTL8029ID1 0x0b /* Realtek ID byte #2 RD */
#define EN0_RSR 0x0c /* rx status reg RD */
#define EN0_RXCR 0x0c /* RX configuration reg WR */
#define EN0_TXCR 0x0d /* TX configuration reg WR */
#define EN2_STARTPG 0x21 /* Starting page of ring bfr RD */
#define EN2_STOPPG 0x22 /* Ending page +1 of ring bfr RD */
+#define EN3_CONFIG0 0x33
+#define EN3_CONFIG1 0x34
+#define EN3_CONFIG2 0x35
+#define EN3_CONFIG3 0x36
+
/* Register accessed at EN_CMD, the 8390 base addr. */
#define E8390_STOP 0x01 /* Stop and reset the chip */
#define E8390_START 0x02 /* Start the chip, clear reset */
case EN2_STOPPG:
ret = s->stop >> 8;
break;
+ case EN0_RTL8029ID0:
+ ret = 0x50;
+ break;
+ case EN0_RTL8029ID1:
+ ret = 0x43;
+ break;
+ case EN3_CONFIG0:
+ ret = 0; /* 10baseT media */
+ break;
+ case EN3_CONFIG2:
+ ret = 0x40; /* 10baseT active */
+ break;
+ case EN3_CONFIG3:
+ ret = 0x40; /* Full duplex */
+ break;
default:
ret = 0x00;
break;