arm64: dts: ti: k3-am625-sk: Add support for USB

AM62 SoC has two instances of USB and they are brought on to the board
in the following way,

-> USB0 instance
 - This is brought out to a USB TypeC connector on board through TPS6598 PD
   controller. The PD controller should decide the role based on CC pin in
   the connector. Unfortunately the irq line for the TPS isn't hooked up
   which is a mode not yet support by the driver (some patches were
   submitted earlier this year[0]). So for now the PD controller is left
   out and peripheral mode chosen.

-> USB1 instance
 - This is brought out to a USB TypeA connector on board.

Therefore, add the required device tree support for the above in the board
dts file.

0: https://lore.kernel.org/lkml/f714ee55-ef47-317d-81b9-57020dda064b@ti.com/T/

Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
Signed-off-by: Sjoerd Simons <sjoerd@collabora.com>
Tested-by: Martyn Welch <martyn.welch@collabora.com>
Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Link: https://lore.kernel.org/r/20230112162847.973869-4-sjoerd@collabora.com

diff --git a/arch/arm64/boot/dts/ti/k3-am625-sk.dts b/arch/arm64/boot/dts/ti/k3-am625-sk.dts
index 4f179b1..6bc7d63 100644 (file)
--- a/arch/arm64/boot/dts/ti/k3-am625-sk.dts
+++ b/arch/arm64/boot/dts/ti/k3-am625-sk.dts
@@ -24,6 +24,8 @@
                spi0 = &ospi0;
                ethernet0 = &cpsw_port1;
                ethernet1 = &cpsw_port2;
+               usb0 = &usb0;
+               usb1 = &usb1;
        };
 
        chosen {
@@ -284,6 +286,12 @@
                        AM62X_IOPAD(0x01d4, PIN_INPUT, 7) /* (B15) UART0_RTSn.GPIO1_23 */
                >;
        };
+
+       main_usb1_pins_default: main-usb1-pins-default {
+               pinctrl-single,pins = <
+                       AM62X_IOPAD(0x0258, PIN_OUTPUT, 0) /* (F18) USB1_DRVVBUS */
+               >;
+       };
 };
 
 &wkup_uart0 {
@@ -464,3 +472,22 @@
                };
        };
 };
+
+&usbss0 {
+       status = "okay";
+       ti,vbus-divider;
+};
+
+&usbss1 {
+       status = "okay";
+};
+
+&usb0 {
+       dr_mode = "peripheral";
+};
+
+&usb1 {
+       dr_mode = "host";
+       pinctrl-names = "default";
+       pinctrl-0 = <&main_usb1_pins_default>;
+};