OSDN Git Service

stmmac: pci: Add dwmac support for Loongson
authorQing Zhang <zhangqing@loongson.cn>
Fri, 18 Jun 2021 02:53:34 +0000 (10:53 +0800)
committerDavid S. Miller <davem@davemloft.net>
Fri, 18 Jun 2021 18:48:34 +0000 (11:48 -0700)
This GMAC module is integrated into the Loongson-2K SoC and the LS7A
bridge chip.

Signed-off-by: Qing Zhang <zhangqing@loongson.cn>
Signed-off-by: Jiaxun Yang <jiaxun.yang@flygoat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/ethernet/stmicro/stmmac/Kconfig
drivers/net/ethernet/stmicro/stmmac/Makefile
drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c [new file with mode: 0644]

index 9a19e4d..ac3c248 100644 (file)
@@ -250,6 +250,15 @@ config DWMAC_INTEL
          This selects the Intel platform specific bus support for the
          stmmac driver. This driver is used for Intel Quark/EHL/TGL.
 
+config DWMAC_LOONGSON
+       tristate "Loongson PCI DWMAC support"
+       default MACH_LOONGSON64
+       depends on STMMAC_ETH && PCI
+       depends on COMMON_CLK
+       help
+         This selects the LOONGSON PCI bus support for the stmmac driver,
+         Support for ethernet controller on Loongson-2K1000 SoC and LS7A1000 bridge.
+
 config STMMAC_PCI
        tristate "STMMAC PCI bus support"
        depends on STMMAC_ETH && PCI
index 6471f93..d4e12e9 100644 (file)
@@ -37,4 +37,5 @@ dwmac-altr-socfpga-objs := altr_tse_pcs.o dwmac-socfpga.o
 
 obj-$(CONFIG_STMMAC_PCI)       += stmmac-pci.o
 obj-$(CONFIG_DWMAC_INTEL)      += dwmac-intel.o
+obj-$(CONFIG_DWMAC_LOONGSON)   += dwmac-loongson.o
 stmmac-pci-objs:= stmmac_pci.o
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c
new file mode 100644 (file)
index 0000000..8cd4e2e
--- /dev/null
@@ -0,0 +1,218 @@
+// SPDX-License-Identifier: GPL-2.0
+/* Copyright (c) 2020, Loongson Corporation
+ */
+
+#include <linux/clk-provider.h>
+#include <linux/pci.h>
+#include <linux/dmi.h>
+#include <linux/device.h>
+#include <linux/of_irq.h>
+#include "stmmac.h"
+
+static int loongson_default_data(struct plat_stmmacenet_data *plat)
+{
+       plat->clk_csr = 2;      /* clk_csr_i = 20-35MHz & MDC = clk_csr_i/16 */
+       plat->has_gmac = 1;
+       plat->force_sf_dma_mode = 1;
+
+       /* Set default value for multicast hash bins */
+       plat->multicast_filter_bins = HASH_TABLE_SIZE;
+
+       /* Set default value for unicast filter entries */
+       plat->unicast_filter_entries = 1;
+
+       /* Set the maxmtu to a default of JUMBO_LEN */
+       plat->maxmtu = JUMBO_LEN;
+
+       /* Set default number of RX and TX queues to use */
+       plat->tx_queues_to_use = 1;
+       plat->rx_queues_to_use = 1;
+
+       /* Disable Priority config by default */
+       plat->tx_queues_cfg[0].use_prio = false;
+       plat->rx_queues_cfg[0].use_prio = false;
+
+       /* Disable RX queues routing by default */
+       plat->rx_queues_cfg[0].pkt_route = 0x0;
+
+       /* Default to phy auto-detection */
+       plat->phy_addr = -1;
+
+       plat->dma_cfg->pbl = 32;
+       plat->dma_cfg->pblx8 = true;
+
+       plat->multicast_filter_bins = 256;
+       return 0;
+}
+
+static int loongson_dwmac_probe(struct pci_dev *pdev, const struct pci_device_id *id)
+{
+       struct plat_stmmacenet_data *plat;
+       struct stmmac_resources res;
+       int ret, i, mdio;
+       struct device_node *np;
+
+       np = dev_of_node(&pdev->dev);
+
+       if (!np) {
+               pr_info("dwmac_loongson_pci: No OF node\n");
+               return -ENODEV;
+       }
+
+       if (!of_device_is_compatible(np, "loongson, pci-gmac")) {
+               pr_info("dwmac_loongson_pci: Incompatible OF node\n");
+               return -ENODEV;
+       }
+
+       plat = devm_kzalloc(&pdev->dev, sizeof(*plat), GFP_KERNEL);
+       if (!plat)
+               return -ENOMEM;
+
+       if (plat->mdio_node) {
+               dev_err(&pdev->dev, "Found MDIO subnode\n");
+               mdio = true;
+       }
+
+       if (mdio) {
+               plat->mdio_bus_data = devm_kzalloc(&pdev->dev,
+                                                  sizeof(*plat->mdio_bus_data),
+                                                  GFP_KERNEL);
+               if (!plat->mdio_bus_data)
+                       return -ENOMEM;
+               plat->mdio_bus_data->needs_reset = true;
+       }
+
+       plat->dma_cfg = devm_kzalloc(&pdev->dev, sizeof(*plat->dma_cfg), GFP_KERNEL);
+       if (!plat->dma_cfg)
+               return -ENOMEM;
+
+       /* Enable pci device */
+       ret = pci_enable_device(pdev);
+       if (ret) {
+               dev_err(&pdev->dev, "%s: ERROR: failed to enable device\n", __func__);
+               return ret;
+       }
+
+       /* Get the base address of device */
+       for (i = 0; i < PCI_STD_NUM_BARS; i++) {
+               if (pci_resource_len(pdev, i) == 0)
+                       continue;
+               ret = pcim_iomap_regions(pdev, BIT(0), pci_name(pdev));
+               if (ret)
+                       return ret;
+               break;
+       }
+
+       plat->bus_id = of_alias_get_id(np, "ethernet");
+       if (plat->bus_id < 0)
+               plat->bus_id = pci_dev_id(pdev);
+
+       plat->phy_interface = device_get_phy_mode(&pdev->dev);
+       if (plat->phy_interface < 0)
+               dev_err(&pdev->dev, "phy_mode not found\n");
+
+       plat->interface = PHY_INTERFACE_MODE_GMII;
+
+       pci_set_master(pdev);
+
+       loongson_default_data(plat);
+       pci_enable_msi(pdev);
+       memset(&res, 0, sizeof(res));
+       res.addr = pcim_iomap_table(pdev)[0];
+
+       res.irq = of_irq_get_byname(np, "macirq");
+       if (res.irq < 0) {
+               dev_err(&pdev->dev, "IRQ macirq not found\n");
+               ret = -ENODEV;
+       }
+
+       res.wol_irq = of_irq_get_byname(np, "eth_wake_irq");
+       if (res.wol_irq < 0) {
+               dev_info(&pdev->dev, "IRQ eth_wake_irq not found, using macirq\n");
+               res.wol_irq = res.irq;
+       }
+
+       res.lpi_irq = of_irq_get_byname(np, "eth_lpi");
+       if (res.lpi_irq < 0) {
+               dev_err(&pdev->dev, "IRQ eth_lpi not found\n");
+               ret = -ENODEV;
+       }
+
+       return stmmac_dvr_probe(&pdev->dev, plat, &res);
+}
+
+static void loongson_dwmac_remove(struct pci_dev *pdev)
+{
+       int i;
+
+       stmmac_dvr_remove(&pdev->dev);
+
+       for (i = 0; i < PCI_STD_NUM_BARS; i++) {
+               if (pci_resource_len(pdev, i) == 0)
+                       continue;
+               pcim_iounmap_regions(pdev, BIT(i));
+               break;
+       }
+
+       pci_disable_device(pdev);
+}
+
+static int __maybe_unused loongson_dwmac_suspend(struct device *dev)
+{
+       struct pci_dev *pdev = to_pci_dev(dev);
+       int ret;
+
+       ret = stmmac_suspend(dev);
+       if (ret)
+               return ret;
+
+       ret = pci_save_state(pdev);
+       if (ret)
+               return ret;
+
+       pci_disable_device(pdev);
+       pci_wake_from_d3(pdev, true);
+       return 0;
+}
+
+static int __maybe_unused loongson_dwmac_resume(struct device *dev)
+{
+       struct pci_dev *pdev = to_pci_dev(dev);
+       int ret;
+
+       pci_restore_state(pdev);
+       pci_set_power_state(pdev, PCI_D0);
+
+       ret = pci_enable_device(pdev);
+       if (ret)
+               return ret;
+
+       pci_set_master(pdev);
+
+       return stmmac_resume(dev);
+}
+
+static SIMPLE_DEV_PM_OPS(loongson_dwmac_pm_ops, loongson_dwmac_suspend,
+                        loongson_dwmac_resume);
+
+static const struct pci_device_id loongson_dwmac_id_table[] = {
+       { PCI_VDEVICE(LOONGSON, 0x7a03) },
+       {}
+};
+MODULE_DEVICE_TABLE(pci, loongson_dwmac_id_table);
+
+struct pci_driver loongson_dwmac_driver = {
+       .name = "dwmac-loongson-pci",
+       .id_table = loongson_dwmac_id_table,
+       .probe = loongson_dwmac_probe,
+       .remove = loongson_dwmac_remove,
+       .driver = {
+               .pm = &loongson_dwmac_pm_ops,
+       },
+};
+
+module_pci_driver(loongson_dwmac_driver);
+
+MODULE_DESCRIPTION("Loongson DWMAC PCI driver");
+MODULE_AUTHOR("Qing Zhang <zhangqing@loongson.cn>");
+MODULE_LICENSE("GPL v2");