#ifdef CONFIG_REGULATOR
/**
+ * mmc_ocrbitnum_to_vdd - Convert a OCR bit number to its voltage
+ * @vdd_bit: OCR bit number
+ * @min_uV: minimum voltage value (mV)
+ * @max_uV: maximum voltage value (mV)
+ *
+ * This function returns the voltage range according to the provided OCR
+ * bit number. If conversion is not possible a negative errno value returned.
+ */
+static int mmc_ocrbitnum_to_vdd(int vdd_bit, int *min_uV, int *max_uV)
+{
+ int tmp;
+
+ if (!vdd_bit)
+ return -EINVAL;
+
+ /*
+ * REVISIT mmc_vddrange_to_ocrmask() may have set some
+ * bits this regulator doesn't quite support ... don't
+ * be too picky, most cards and regulators are OK with
+ * a 0.1V range goof (it's a small error percentage).
+ */
+ tmp = vdd_bit - ilog2(MMC_VDD_165_195);
+ if (tmp == 0) {
+ *min_uV = 1650 * 1000;
+ *max_uV = 1950 * 1000;
+ } else {
+ *min_uV = 1900 * 1000 + tmp * 100 * 1000;
+ *max_uV = *min_uV + 100 * 1000;
+ }
+
+ return 0;
+}
+
+/**
* mmc_regulator_get_ocrmask - return mask of supported voltages
* @supply: regulator to use
*
int min_uV, max_uV;
if (vdd_bit) {
- int tmp;
-
- /*
- * REVISIT mmc_vddrange_to_ocrmask() may have set some
- * bits this regulator doesn't quite support ... don't
- * be too picky, most cards and regulators are OK with
- * a 0.1V range goof (it's a small error percentage).
- */
- tmp = vdd_bit - ilog2(MMC_VDD_165_195);
- if (tmp == 0) {
- min_uV = 1650 * 1000;
- max_uV = 1950 * 1000;
- } else {
- min_uV = 1900 * 1000 + tmp * 100 * 1000;
- max_uV = min_uV + 100 * 1000;
- }
+ mmc_ocrbitnum_to_vdd(vdd_bit, &min_uV, &max_uV);
result = regulator_set_voltage(supply, min_uV, max_uV);
if (result == 0 && !mmc->regulator_enabled) {