#define REG_GPIO_MUXCFG 0x0040
#define BIT_FSPI_EN BIT(19)
#define BIT_EN_SIC BIT(12)
-#define BIT_BT_AOD_GPIO3 BIT(9)
+
#define BIT_PO_BT_PTA_PINS BIT(9)
#define BIT_BT_PTA_EN BIT(5)
#define BIT_WLRFE_4_5_EN BIT(2)
#define REG_BT_COEX_TABLE_H3 0x06CF
#define REG_BBPSF_CTRL 0x06DC
-#define REG_BT_COEX_V2 0x0763
-#define BIT_GNT_BT_POLARITY BIT(4)
+#define REG_BT_COEX_V2 0x0762
+#define BIT_GNT_BT_POLARITY BIT(12)
#define BIT_LTE_COEX_EN BIT(7)
#define REG_BT_STAT_CTRL 0x0778
#define REG_BT_TDMA_TIME 0x0790
+#define BIT_MASK_SAMPLE_RATE GENMASK(5, 0)
#define REG_LTR_IDLE_LATENCY 0x0798
#define REG_LTR_ACTIVE_LATENCY 0x079C
#define REG_LTR_CTRL_BASIC 0x07A4
/* BT report packet sample rate */
/* 0x790[5:0]=0x5 */
- rtw_write8_set(rtwdev, REG_BT_TDMA_TIME, 0x05);
+ rtw_write8_mask(rtwdev, REG_BT_TDMA_TIME, BIT_MASK_SAMPLE_RATE, 0x5);
/* enable BT counter statistics */
rtw_write8(rtwdev, REG_BT_STAT_CTRL, 0x1);
/* enable PTA (3-wire function form BT side) */
rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_BT_PTA_EN);
- rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_BT_AOD_GPIO3);
+ rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_PO_BT_PTA_PINS);
/* enable PTA (tx/rx signal form WiFi side) */
rtw_write8_set(rtwdev, REG_QUEUE_CTRL, BIT_PTA_WL_TX_EN);
rtw_write8_set(rtwdev, REG_BCN_CTRL, BIT_EN_BCN_FUNCTION);
/* BT report packet sample rate */
- rtw_write8_mask(rtwdev, REG_BT_TDMA_TIME, SAMPLE_RATE_MASK,
- SAMPLE_RATE);
+ rtw_write8_mask(rtwdev, REG_BT_TDMA_TIME, BIT_MASK_SAMPLE_RATE, 0x5);
/* enable BT counter statistics */
rtw_write8(rtwdev, REG_BT_STAT_CTRL, BT_CNT_ENABLE);
#define REG_IQKFAILMSK 0x1bf0
#define BIT_MASK_R_RFE_SEL_15 GENMASK(31, 28)
#define BIT_SDIO_INT BIT(18)
-#define SAMPLE_RATE_MASK GENMASK(5, 0)
-#define SAMPLE_RATE 0x5
#define BT_CNT_ENABLE 0x1
#define BIT_BCN_QUEUE BIT(3)
#define BCN_PRI_EN 0x1
/* BT report packet sample rate */
/* 0x790[5:0]=0x5 */
- rtw_write8_set(rtwdev, REG_BT_TDMA_TIME, 0x05);
+ rtw_write8_mask(rtwdev, REG_BT_TDMA_TIME, BIT_MASK_SAMPLE_RATE, 0x5);
/* enable BT counter statistics */
rtw_write8(rtwdev, REG_BT_STAT_CTRL, 0x1);
/* enable PTA (3-wire function form BT side) */
rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_BT_PTA_EN);
- rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_BT_AOD_GPIO3);
+ rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_PO_BT_PTA_PINS);
/* enable PTA (tx/rx signal form WiFi side) */
rtw_write8_set(rtwdev, REG_QUEUE_CTRL, BIT_PTA_WL_TX_EN);
/* wl tx signal to PTA not case EDCCA */
rtw_write8_clr(rtwdev, REG_QUEUE_CTRL, BIT_PTA_EDCCA_EN);
/* GNT_BT=1 while select both */
- rtw_write8_set(rtwdev, REG_BT_COEX_V2, BIT_GNT_BT_POLARITY);
+ rtw_write16_set(rtwdev, REG_BT_COEX_V2, BIT_GNT_BT_POLARITY);
}
static void rtw8822b_coex_cfg_ant_switch(struct rtw_dev *rtwdev,
/* enable TBTT nterrupt */
rtw_write8_set(rtwdev, REG_BCN_CTRL, BIT_EN_BCN_FUNCTION);
- /* BT report packet sample rate */
+ /* BT report packet sample rate */
/* 0x790[5:0]=0x5 */
- rtw_write8_set(rtwdev, REG_BT_TDMA_TIME, 0x05);
+ rtw_write8_mask(rtwdev, REG_BT_TDMA_TIME, BIT_MASK_SAMPLE_RATE, 0x5);
/* enable BT counter statistics */
rtw_write8(rtwdev, REG_BT_STAT_CTRL, 0x1);
/* enable PTA (3-wire function form BT side) */
rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_BT_PTA_EN);
- rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_BT_AOD_GPIO3);
+ rtw_write32_set(rtwdev, REG_GPIO_MUXCFG, BIT_PO_BT_PTA_PINS);
/* enable PTA (tx/rx signal form WiFi side) */
rtw_write8_set(rtwdev, REG_QUEUE_CTRL, BIT_PTA_WL_TX_EN);
/* wl tx signal to PTA not case EDCCA */
rtw_write8_clr(rtwdev, REG_QUEUE_CTRL, BIT_PTA_EDCCA_EN);
/* GNT_BT=1 while select both */
- rtw_write8_set(rtwdev, REG_BT_COEX_V2, BIT_GNT_BT_POLARITY);
- /* BT_CCA = ~GNT_WL_BB, (not or GNT_BT_BB, LTE_Rx */
+ rtw_write16_set(rtwdev, REG_BT_COEX_V2, BIT_GNT_BT_POLARITY);
+ /* BT_CCA = ~GNT_WL_BB, not or GNT_BT_BB, LTE_Rx */
rtw_write8_clr(rtwdev, REG_DUMMY_PAGE4_V1, BIT_BTCCA_CTRL);
/* to avoid RF parameter error */