rtl8xxxu: Set correct interrupt masking registers on 8192eu

Set HIMR[01] on 8192eu instead of HISR/HIMR. It's not obvious this
really matters for USB devices, but this matches the register writes
performed by the vendor driver.

Signed-off-by: Jes Sorensen <Jes.Sorensen@redhat.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
index e770192..bcf229d 100644 (file)
--- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
+++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
@@ -6883,11 +6883,6 @@ static int rtl8xxxu_init_device(struct ieee80211_hw *hw)
                rtl8xxxu_write8(priv, 0xfe42, 0x80);
        }
 
-       if (priv->rtl_chip == RTL8192E) {
-               rtl8xxxu_write32(priv, REG_HIMR0, 0x00);
-               rtl8xxxu_write32(priv, REG_HIMR1, 0x00);
-       }
-
        if (priv->fops->phy_init_antenna_selection)
                priv->fops->phy_init_antenna_selection(priv);
 
@@ -7053,11 +7048,16 @@ static int rtl8xxxu_init_device(struct ieee80211_hw *hw)
         */
        rtl8xxxu_write8(priv, REG_RX_DRVINFO_SZ, 4);
 
-       /*
-        * Enable all interrupts - not obvious USB needs to do this
-        */
-       rtl8xxxu_write32(priv, REG_HISR, 0xffffffff);
-       rtl8xxxu_write32(priv, REG_HIMR, 0xffffffff);
+       if (priv->rtl_chip == RTL8192E) {
+               rtl8xxxu_write32(priv, REG_HIMR0, 0x00);
+               rtl8xxxu_write32(priv, REG_HIMR1, 0x00);
+       } else {
+               /*
+                * Enable all interrupts - not obvious USB needs to do this
+                */
+               rtl8xxxu_write32(priv, REG_HISR, 0xffffffff);
+               rtl8xxxu_write32(priv, REG_HIMR, 0xffffffff);
+       }
 
        rtl8xxxu_set_mac(priv);
        rtl8xxxu_set_linktype(priv, NL80211_IFTYPE_STATION);