net: phy: call phy_disable_interrupts() in phy_attach_direct() instead

Since the micrel phy driver calls phy_init_hw() as a workaround,
the commit 9886a4dbd2aa ("net: phy: call phy_disable_interrupts()
in phy_init_hw()") disables the interrupt unexpectedly. So,
call phy_disable_interrupts() in phy_attach_direct() instead.
Otherwise, the phy cannot link up after the ethernet cable was
disconnected.

Note that other drivers (like at803x.c) also calls phy_init_hw().
So, perhaps, the driver caused a similar issue too.

Fixes: 9886a4dbd2aa ("net: phy: call phy_disable_interrupts() in phy_init_hw()")
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 8adfbad..b93b40c 100644 (file)
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -1143,10 +1143,6 @@ int phy_init_hw(struct phy_device *phydev)
        if (ret < 0)
                return ret;
 
-       ret = phy_disable_interrupts(phydev);
-       if (ret)
-               return ret;
-
        if (phydev->drv->config_init)
                ret = phydev->drv->config_init(phydev);
 
@@ -1423,6 +1419,10 @@ int phy_attach_direct(struct net_device *dev, struct phy_device *phydev,
        if (err)
                goto error;
 
+       err = phy_disable_interrupts(phydev);
+       if (err)
+               return err;
+
        phy_resume(phydev);
        phy_led_triggers_register(phydev);