media: camss: csid-170: remove stray comment

This is a leftover from my original patches, it doesn't serve any purpose.
(it was a reminder to figure out how downstream sets a particular field in
the register).

Fixes: eebe6d00e9bf ("media: camss: Add support for CSID hardware version Titan 170")
Signed-off-by: Jonathan Marek <jonathan@marek.ca>
Reviewed-by: Robert Foss <robert.foss@linaro.org>
Tested-by: Julian Grahsl <jgrahsl@snap.com>
Tested-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>

diff --git a/drivers/media/platform/qcom/camss/camss-csid-170.c b/drivers/media/platform/qcom/camss/camss-csid-170.c
index a006c8d..f0c6a72 100644 (file)
--- a/drivers/media/platform/qcom/camss/camss-csid-170.c
+++ b/drivers/media/platform/qcom/camss/camss-csid-170.c
@@ -442,7 +442,7 @@ static void csid_configure_stream(struct csid_device *csid, u8 enable)
 
        val = 1 << CSI2_RX_CFG1_PACKET_ECC_CORRECTION_EN;
        val |= 1 << CSI2_RX_CFG1_MISR_EN;
-       writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1); // csi2_vc_mode_shift_val ?
+       writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1);
 
        val = 1 << RDI_CTRL_HALT_CMD;
        writel_relaxed(val, csid->base + CSID_RDI_CTRL(0));