Currently we schedule a call to output_poll_execute from
drm_kms_helper_poll_enable for 10s in future. Later we try to replace
that in drm_helper_probe_single_connector_modes with a 0s schedule with
delayed_event set.
But as there is already a job in the queue this fails, and the immediate
job we wanted with delayed_event set doesn't occur until 10s later.
And that call acts as if connector state has changed, reprobing modes.
This has a side effect of waking up a display that has been blanked.
Make sure we cancel the old job before submitting the immediate one.
Fixes:
162b6a57ac50 ("drm/probe-helper: don't lose hotplug event")
Acked-by: Daniel Vetter <daniel@ffwll.ch>
Signed-off-by: Dom Cobley <popcornmix@gmail.com>
[Maxime: Switched to mod_delayed_work]
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Link: https://patchwork.freedesktop.org/patch/msgid/20230127154052.452524-1-maxime@cerno.tech
*/
dev->mode_config.delayed_event = true;
if (dev->mode_config.poll_enabled)
- schedule_delayed_work(&dev->mode_config.output_poll_work,
- 0);
+ mod_delayed_work(system_wq,
+ &dev->mode_config.output_poll_work,
+ 0);
}
/* Re-enable polling in case the global poll config changed. */