enum dwarf2_reg_rule
{
- /* Make certain that 0 maps onto the correct enum value - the
+ /* Make certain that 0 maps onto the correct enum value; the
corresponding structure is being initialized using memset zero.
This indicates that CFI didn't provide any information at all
- about a register - leaving how to obtain it's value totally
+ about a register, leaving how to obtain it's value totally
unspecified. */
REG_UNSPECIFIED = 0,
/* The term "undefined" comes from the DWARF2 CFI spec which this
- code is moddeling - it indicates that the register's value is
- "undefined". */
- /* NOTE: cagney/2003-09-08: GCC uses the less formal term "unsaved"
- - it's definition is a combination of REG_UNDEFINED and
- REG_UNSPECIFIED - the failure to differentiate the two helps
- explain a few problems with the CFI GCC outputs. */
+ code is moddeling; it indicates that the register's value is
+ "undefined". GCC uses the less formal term "unsaved". Its
+ definition is a combination of REG_UNDEFINED and REG_UNSPECIFIED.
+ The failure to differentiate the two helps explain a few problems
+ with the CFI generated by GCC. */
REG_UNDEFINED,
REG_SAVED_OFFSET,
REG_SAVED_REG,
to abort), the compiler might optimize away the instruction at
NEXT_FRAME's return address. As a result the return address will
point at some random instruction, and the CFI for that
- instruction is probably wortless to us. GCC's unwinder solves
+ instruction is probably worthless to us. GCC's unwinder solves
this problem by substracting 1 from the return address to get an
address in the middle of a presumed call instruction (or the
instruction in the associated delay slot). This should only be
done for "normal" frames and not for resume-type frames (signal
- handlers, sentinel frames, dummy frames).
-
- frame_unwind_address_in_block does just this.
-
- It's not clear how reliable the method is though - there is the
- potential for the register state pre-call being different to that
- on return. */
+ handlers, sentinel frames, dummy frames). The function
+ frame_unwind_address_in_block does just this. It's not clear how
+ reliable the method is though; there is the potential for the
+ register state pre-call being different to that on return. */
fs->pc = frame_unwind_address_in_block (next_frame);
/* Find the correct FDE. */
unspecified. */
{
int regnum;
+
for (regnum = 0; regnum < num_regs; regnum++)
cache->reg[regnum].how = REG_UNSPECIFIED;
}
location information in the cache. */
{
int column; /* CFI speak for "register number". */
+
for (column = 0; column < fs->regs.num_regs; column++)
{
int regnum;
RETADDR_COLUMN corresponds to a real register (and,
worse, that isn't the PC_REGNUM)? I'm guessing that the
PC_REGNUM further down is trying to handle this. That
- can't be right though - PC_REGNUM may not be valid (it
- can be -ve). I think, instead when RETADDR_COLUM isn't a
- real register, it should map itself onto frame_pc_unwind. */
+ can't be right though; PC_REGNUM may not be valid (it can
+ be negative). I think, instead when RETADDR_COLUM isn't
+ a real register, it should map itself onto
+ frame_pc_unwind. */
continue;
/* Use the GDB register number as the destination index. */
continue;
/* NOTE: cagney/2003-09-05: CFI should specify the disposition
- of all debug info registers. If it doesn't complain (but
- not too loudly). It turns out that GCC, assumes that an
+ of all debug info registers. If it doesn't, complain (but
+ not too loudly). It turns out that GCC assumes that an
unspecified register implies "same value" when CFI (draft
7) specifies nothing at all. Such a register could equally
be interpreted as "undefined". Also note that this check
- isn't sufficient - it only checks that all registers in the
- range [0 .. max column] are specified - and won't detect
+ isn't sufficient; it only checks that all registers in the
+ range [0 .. max column] are specified, and won't detect
problems when a debug info register falls outside of the
- table. Need a way of iterating through all the valid
+ table. We need a way of iterating through all the valid
DWARF2 register numbers. */
if (fs->regs.reg[column].how == REG_UNSPECIFIED)
complaint (&symfile_complaints,
}
/* Store the location of the return addess. If the return address
- column (adjusted) is not the same as gdb's PC_REGNUM, then this
- implies a copy from the ra column register. */
+ column (adjusted) is not the same as GDB's PC_REGNUM, then this
+ implies a copy from the return address column register. */
if (fs->retaddr_column < fs->regs.num_regs
&& fs->regs.reg[fs->retaddr_column].how != REG_UNDEFINED)
{
- /* See comment above about a possibly -ve PC_REGNUM. If this
- assertion fails, it's a problem with this code and not the
- architecture. */
+ /* See comment above about a possibly negative PC_REGNUM. If
+ this assertion fails, it's a problem with this code and not
+ the architecture. */
gdb_assert (PC_REGNUM >= 0);
cache->reg[PC_REGNUM] = fs->regs.reg[fs->retaddr_column];
}
int reg = DWARF2_REG_TO_REGNUM (fs->retaddr_column);
if (reg != PC_REGNUM)
{
- /* See comment above about PC_REGNUM being -ve. If this
- assertion fails, it's a problem with this code and not
- the architecture. */
+ /* See comment above about PC_REGNUM being negative. If
+ this assertion fails, it's a problem with this code and
+ not the architecture. */
gdb_assert (PC_REGNUM >= 0);
cache->reg[PC_REGNUM].loc.reg = reg;
cache->reg[PC_REGNUM].how = REG_SAVED_REG;
{
case REG_UNDEFINED:
/* If CFI explicitly specified that the value isn't defined,
- mark it as optimized away - the value isn't available. */
+ mark it as optimized away; the value isn't available. */
*optimizedp = 1;
*lvalp = not_lval;
*addrp = 0;
/* FIXME: cagney/2003-07-07: I don't understand this. The
CFI info should have provided unwind information for the
SP register and then pointed ->cfa_reg at it, not the
- reverse. Assuming that SP_REGNUM is !-ve, there is a
- very real posibility that CFA is an offset from some
+ reverse. Assuming that SP_REGNUM isn't negative, there
+ is a very real posibility that CFA is an offset from some
other register, having nothing to do with the unwound SP
value. */
/* FIXME: cagney/2003-09-05: I think I understand. GDB was
defines the rule which computes the CFA value; it may be
either a register and a signed offset that are added
together or a DWARF expression that is evaluated. */
- /* NOTE: cagney/2003-09-05: Should issue a complain.
+ /* NOTE: cagney/2003-09-05: Should issue a complaint.
Unfortunately it turns out that DWARF2 CFI has a problem.
Since CFI specifies the location at which a register was
saved (not its value) it isn't possible to specify
OSDN Git Service
