The driver shouldn't be able to issue End Transfer to the control
endpoint at anytime. Typically we should only do so in error cases such
as invalid/unexpected direction of Data Phase as described in the
control transfer flow of the programming guide. It _may_ end started
data phase during controller deinitialization from soft disconnect or
driver removal. However, that should not happen because the driver
should be maintained in EP0_SETUP_PHASE during driver tear-down. On
soft-connect, the controller should be reset from a soft-reset and there
should be no issue starting the control endpoint.
Signed-off-by: Thinh Nguyen <Thinh.Nguyen@synopsys.com>
Link: https://lore.kernel.org/r/3c6643678863a26702e4115e9e19d7d94a30d49c.1650593829.git.Thinh.Nguyen@synopsys.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
void dwc3_stop_active_transfer(struct dwc3_ep *dep, bool force,
bool interrupt)
{
+ struct dwc3 *dwc = dep->dwc;
+
+ /*
+ * Only issue End Transfer command to the control endpoint of a started
+ * Data Phase. Typically we should only do so in error cases such as
+ * invalid/unexpected direction as described in the control transfer
+ * flow of the programming guide.
+ */
+ if (dep->number <= 1 && dwc->ep0state != EP0_DATA_PHASE)
+ return;
+
if (!(dep->flags & DWC3_EP_TRANSFER_STARTED) ||
(dep->flags & DWC3_EP_DELAY_STOP) ||
(dep->flags & DWC3_EP_END_TRANSFER_PENDING))