usb: Kconfig: move ulpi bus support out of host

The ULPI bus is not only for host, but for device mode too, so move
it out from host's Kconfig.

Signed-off-by: Peter Chen <peter.chen@nxp.com>
Acked-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/usb/Kconfig b/drivers/usb/Kconfig
index 8689dcb..6dfa10a 100644 (file)
--- a/drivers/usb/Kconfig
+++ b/drivers/usb/Kconfig
@@ -160,4 +160,24 @@ config USB_LED_TRIG
          LEDs and you want to use them as activity indicators for USB host or
          gadget.
 
+config USB_ULPI_BUS
+       tristate "USB ULPI PHY interface support"
+       help
+         UTMI+ Low Pin Interface (ULPI) is specification for a commonly used
+         USB 2.0 PHY interface. The ULPI specification defines a standard set
+         of registers that can be used to detect the vendor and product which
+         allows ULPI to be handled as a bus. This module is the driver for that
+         bus.
+
+         The ULPI interfaces (the buses) are registered by the drivers for USB
+         controllers which support ULPI register access and have ULPI PHY
+         attached to them. The ULPI PHY drivers themselves are normal PHY
+         drivers.
+
+         ULPI PHYs provide often functions such as ADP sensing/probing (OTG
+         protocol) and USB charger detection.
+
+         To compile this driver as a module, choose M here: the module will
+         be called ulpi.
+
 endif # USB_SUPPORT

diff --git a/drivers/usb/core/Kconfig b/drivers/usb/core/Kconfig
index 253aac7..d6e43ce 100644 (file)
--- a/drivers/usb/core/Kconfig
+++ b/drivers/usb/core/Kconfig
@@ -82,23 +82,3 @@ config USB_OTG_FSM
        help
          Implements OTG Finite State Machine as specified in On-The-Go
          and Embedded Host Supplement to the USB Revision 2.0 Specification.
-
-config USB_ULPI_BUS
-       tristate "USB ULPI PHY interface support"
-       help
-         UTMI+ Low Pin Interface (ULPI) is specification for a commonly used
-         USB 2.0 PHY interface. The ULPI specification defines a standard set
-         of registers that can be used to detect the vendor and product which
-         allows ULPI to be handled as a bus. This module is the driver for that
-         bus.
-
-         The ULPI interfaces (the buses) are registered by the drivers for USB
-         controllers which support ULPI register access and have ULPI PHY
-         attached to them. The ULPI PHY drivers themselves are normal PHY
-         drivers.
-
-         ULPI PHYs provide often functions such as ADP sensing/probing (OTG
-         protocol) and USB charger detection.
-
-         To compile this driver as a module, choose M here: the module will
-         be called ulpi.