/**
* struct ti_abb_info - ABB information per voltage setting
* @opp_sel: one of TI_ABB macro
- * @vset: (optional) vset value that LDOVBB needs to be overriden with.
+ * @vset: (optional) vset value that LDOVBB needs to be overridden with.
*
* Array of per voltage entries organized in the same order as regulator_desc's
* volt_table list. (selector is used to index from this array)
/* Calculate cycle rate */
cycle_rate = DIV_ROUND_CLOSEST(clock_cycles * 10, clk_rate);
- /* Calulate SR2_WTCNT_VALUE */
+ /* Calculate SR2_WTCNT_VALUE */
sr2_wt_cnt_val = DIV_ROUND_CLOSEST(abb->settling_time * 10, cycle_rate);
dev_dbg(dev, "%s: Clk_rate=%ld, sr2_cnt=0x%08x\n", __func__,
* @pdev: ABB platform device
*
* Initializes an individual ABB LDO for required Body-Bias. ABB is used to
- * addional bias supply to SoC modules for power savings or mandatory stability
+ * additional bias supply to SoC modules for power savings or mandatory stability
* configuration at certain Operating Performance Points(OPPs).
*
* Return: 0 on success or appropriate error value when fails
if (pdev->id < WM8350_DCDC_1 || pdev->id > WM8350_ISINK_B)
return -ENODEV;
- /* do any regulatior specific init */
+ /* do any regulator specific init */
switch (pdev->id) {
case WM8350_DCDC_1:
val = wm8350_reg_read(wm8350, WM8350_DCDC1_LOW_POWER);