phy/marvell: remove fiber/copper autoselect on 88e1111

Remove the code that always enables copper/fiber autoselect,
ignoring the DIS_FC strapping pin. The default value for this
register is autoselect on anyway, and if you explicitly disable
autoselect via strapping you probably really don't want
autoselect.

Signed-off-by: Stef van Os <stef.van.os@prodrive.nl>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
index 5d2a3f2..22dec9c 100644 (file)
--- a/drivers/net/phy/marvell.c
+++ b/drivers/net/phy/marvell.c
@@ -353,15 +353,6 @@ static int m88e1111_config_init(struct phy_device *phydev)
        int err;
        int temp;
 
-       /* Enable Fiber/Copper auto selection */
-       temp = phy_read(phydev, MII_M1111_PHY_EXT_SR);
-       temp &= ~MII_M1111_HWCFG_FIBER_COPPER_AUTO;
-       phy_write(phydev, MII_M1111_PHY_EXT_SR, temp);
-
-       temp = phy_read(phydev, MII_BMCR);
-       temp |= BMCR_RESET;
-       phy_write(phydev, MII_BMCR, temp);
-
        if ((phydev->interface == PHY_INTERFACE_MODE_RGMII) ||
            (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID) ||
            (phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID) ||