ARM: shmobile: ape6evm dts: Fix polarity of LEDs

While the LEDs on r8a73a4/ape6evm are tied to VSUPPLY, they're driven by
an N-channel MOSFET. Hence the GPIO signal should be active high.

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>

diff --git a/arch/arm/boot/dts/r8a73a4-ape6evm.dts b/arch/arm/boot/dts/r8a73a4-ape6evm.dts
index 0d50bef..e8f3f38 100644 (file)
--- a/arch/arm/boot/dts/r8a73a4-ape6evm.dts
+++ b/arch/arm/boot/dts/r8a73a4-ape6evm.dts
@@ -95,27 +95,27 @@
        leds {
                compatible = "gpio-leds";
                led1 {
-                       gpios = <&pfc 28 GPIO_ACTIVE_LOW>;
+                       gpios = <&pfc 28 GPIO_ACTIVE_HIGH>;
                        label = "GNSS_EN";
                };
                led2 {
-                       gpios = <&pfc 126 GPIO_ACTIVE_LOW>;
+                       gpios = <&pfc 126 GPIO_ACTIVE_HIGH>;
                        label = "NFC_NRST";
                };
                led3 {
-                       gpios = <&pfc 132 GPIO_ACTIVE_LOW>;
+                       gpios = <&pfc 132 GPIO_ACTIVE_HIGH>;
                        label = "GNSS_NRST";
                };
                led4 {
-                       gpios = <&pfc 232 GPIO_ACTIVE_LOW>;
+                       gpios = <&pfc 232 GPIO_ACTIVE_HIGH>;
                        label = "BT_WAKEUP";
                };
                led5 {
-                       gpios = <&pfc 250 GPIO_ACTIVE_LOW>;
+                       gpios = <&pfc 250 GPIO_ACTIVE_HIGH>;
                        label = "STROBE";
                };
                led6 {
-                       gpios = <&pfc 288 GPIO_ACTIVE_LOW>;
+                       gpios = <&pfc 288 GPIO_ACTIVE_HIGH>;
                        label = "BBRESETOUT";
                };
        };