arm64: dts: qcom: pm6150l: add temp sensor and thermal zone config

Add temp-alarm device tree node and a default configuration for the
corresponding thermal zone for this PMIC. Temperatures are based on
downstream values, except for trip2 where 125°C is used instead of 145°C
due to limitations without a configured ADC.

Signed-off-by: Luca Weiss <luca.weiss@fairphone.com>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20221028075405.124809-2-luca.weiss@fairphone.com

diff --git a/arch/arm64/boot/dts/qcom/pm6150l.dtsi b/arch/arm64/boot/dts/qcom/pm6150l.dtsi
index 8a7c18b..0cf99a5 100644 (file)
--- a/arch/arm64/boot/dts/qcom/pm6150l.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm6150l.dtsi
@@ -5,6 +5,37 @@
 #include <dt-bindings/interrupt-controller/irq.h>
 #include <dt-bindings/spmi/spmi.h>
 
+/ {
+       thermal-zones {
+               pm6150l-thermal {
+                       polling-delay-passive = <0>;
+                       polling-delay = <0>;
+
+                       thermal-sensors = <&pm6150l_temp>;
+
+                       trips {
+                               trip0 {
+                                       temperature = <95000>;
+                                       hysteresis = <0>;
+                                       type = "passive";
+                               };
+
+                               trip1 {
+                                       temperature = <115000>;
+                                       hysteresis = <0>;
+                                       type = "hot";
+                               };
+
+                               trip2 {
+                                       temperature = <125000>;
+                                       hysteresis = <0>;
+                                       type = "critical";
+                               };
+                       };
+               };
+       };
+};
+
 &spmi_bus {
        pm6150l_lsid4: pmic@4 {
                compatible = "qcom,pm6150l", "qcom,spmi-pmic";
@@ -12,6 +43,13 @@
                #address-cells = <1>;
                #size-cells = <0>;
 
+               pm6150l_temp: temp-alarm@2400 {
+                       compatible = "qcom,spmi-temp-alarm";
+                       reg = <0x2400>;
+                       interrupts = <0x4 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
+                       #thermal-sensor-cells = <0>;
+               };
+
                pm6150l_adc: adc@3100 {
                        compatible = "qcom,spmi-adc5";
                        reg = <0x3100>;