dt-bindings: iio: srf04: add Maxbotix ultrasonic iio proximity sensors

add compatibles for Maxbotix ultrasonic iio sensor types to yaml
documentation

Signed-off-by: Andreas Klinger <ak@it-klinger.de>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>

diff --git a/Documentation/devicetree/bindings/iio/proximity/devantech-srf04.yaml b/Documentation/devicetree/bindings/iio/proximity/devantech-srf04.yaml
index e7aab78..4e80ea7 100644 (file)
--- a/Documentation/devicetree/bindings/iio/proximity/devantech-srf04.yaml
+++ b/Documentation/devicetree/bindings/iio/proximity/devantech-srf04.yaml
@@ -4,7 +4,7 @@
 $id: http://devicetree.org/schemas/iio/proximity/devantech-srf04.yaml#
 $schema: http://devicetree.org/meta-schemas/core.yaml#
 
-title: Devantech SRF04 ultrasonic range finder
+title: Devantech SRF04 and Maxbotix mb1000 ultrasonic range finder
 
 maintainers:
   - Andreas Klinger <ak@it-klinger.de>
@@ -16,19 +16,28 @@ description: |
   - echo-gpio is held high by the sensor after sending ultrasonic burst
     until it is received once again
 
-  Specifications about the driver can be found at:
+  Specifications about the devices can be found at:
   http://www.robot-electronics.co.uk/htm/srf04tech.htm
 
+  http://www.maxbotix.com/documents/LV-MaxSonar-EZ_Datasheet.pdf
+
 properties:
   compatible:
-    items:
-      - const: devantech,srf04
+    enum:
+      - devantech,srf04
+      - maxbotix,mb1000
+      - maxbotix,mb1010
+      - maxbotix,mb1020
+      - maxbotix,mb1030
+      - maxbotix,mb1040
 
   trig-gpios:
     description:
-      Definition of the GPIO for the triggering (output) This GPIO is set
-      for about 10 us by the driver to tell the device it should initiate
-      the measurement cycle.
+      Definition of the GPIO for the triggering (output)
+      This GPIO is set for about 10 us by the driver to tell the device it
+      should initiate the measurement cycle.
+      See Documentation/devicetree/bindings/gpio/gpio.txt for information
+      on how to specify a consumer gpio.
     maxItems: 1
 
   echo-gpios:
@@ -40,8 +49,6 @@ properties:
       trip.
       It needs to be an GPIO which is able to deliver an interrupt because
       the time between two interrupts is measured in the driver.
-      See Documentation/devicetree/bindings/gpio/gpio.txt for information
-      on how to specify a consumer gpio.
     maxItems: 1
 
 required: