phba->cfg_link_speed);
mbxstatus = lpfc_sli_issue_mbox_wait(phba, pmboxq,
phba->fc_ratov * 2);
+ if ((mbxstatus == MBX_SUCCESS) &&
+ (pmboxq->u.mb.mbxStatus == MBXERR_SEC_NO_PERMISSION))
+ lpfc_printf_log(phba, KERN_ERR, LOG_MBOX | LOG_SLI,
+ "2859 SLI authentication is required "
+ "for INIT_LINK but has not done yet\n");
}
lpfc_set_loopback_flag(phba);
case MBX_PORT_CAPABILITIES:
case MBX_PORT_IOV_CONTROL:
break;
+ case MBX_SECURITY_MGMT:
+ case MBX_AUTH_PORT:
+ if (phba->pci_dev_grp == LPFC_PCI_DEV_OC)
+ return -EPERM;
+ break;
case MBX_READ_SPARM64:
case MBX_READ_LA:
case MBX_READ_LA64:
#define MBX_INIT_VFI 0xA3
#define MBX_INIT_VPI 0xA4
+#define MBX_AUTH_PORT 0xF8
+#define MBX_SECURITY_MGMT 0xF9
+
/* IOCB Commands */
#define CMD_RCV_SEQUENCE_CX 0x01
#define MBXERR_DMA_ERROR 15
#define MBXERR_ERROR 16
#define MBXERR_LINK_DOWN 0x33
-#define MBX_NOT_FINISHED 255
+#define MBXERR_SEC_NO_PERMISSION 0xF02
+#define MBX_NOT_FINISHED 255
#define MBX_BUSY 0xffffff /* Attempted cmd to busy Mailbox */
#define MBX_TIMEOUT 0xfffffe /* time-out expired waiting for */
} else {
/*
* If heart beat timeout called with hb_outstanding set
- * we need to take the HBA offline.
+ * we need to give the hb mailbox cmd a chance to
+ * complete or TMO.
*/
- lpfc_printf_log(phba, KERN_ERR, LOG_INIT,
- "0459 Adapter heartbeat failure, "
- "taking this port offline.\n");
-
- spin_lock_irq(&phba->hbalock);
- psli->sli_flag &= ~LPFC_SLI_ACTIVE;
- spin_unlock_irq(&phba->hbalock);
-
- lpfc_offline_prep(phba);
- lpfc_offline(phba);
- lpfc_unblock_mgmt_io(phba);
- phba->link_state = LPFC_HBA_ERROR;
- lpfc_hba_down_post(phba);
+ lpfc_printf_log(phba, KERN_WARNING, LOG_INIT,
+ "0459 Adapter heartbeat still out"
+ "standing:last compl time was %d ms.\n",
+ jiffies_to_msecs(jiffies
+ - phba->last_completion_time));
+ mod_timer(&phba->hb_tmofunc,
+ jiffies + HZ * LPFC_HB_MBOX_TIMEOUT);
}
}
}
if (phba->hba_flag & DEFER_ERATT)
lpfc_handle_deferred_eratt(phba);
- if (phba->work_hs & HS_FFER6) {
- /* Re-establishing Link */
- lpfc_printf_log(phba, KERN_INFO, LOG_LINK_EVENT,
- "1301 Re-establishing Link "
- "Data: x%x x%x x%x\n",
- phba->work_hs,
- phba->work_status[0], phba->work_status[1]);
+ if ((phba->work_hs & HS_FFER6) || (phba->work_hs & HS_FFER8)) {
+ if (phba->work_hs & HS_FFER6)
+ /* Re-establishing Link */
+ lpfc_printf_log(phba, KERN_INFO, LOG_LINK_EVENT,
+ "1301 Re-establishing Link "
+ "Data: x%x x%x x%x\n",
+ phba->work_hs, phba->work_status[0],
+ phba->work_status[1]);
+ if (phba->work_hs & HS_FFER8)
+ /* Device Zeroization */
+ lpfc_printf_log(phba, KERN_INFO, LOG_LINK_EVENT,
+ "2861 Host Authentication device "
+ "zeroization Data:x%x x%x x%x\n",
+ phba->work_hs, phba->work_status[0],
+ phba->work_status[1]);
spin_lock_irq(&phba->hbalock);
psli->sli_flag &= ~LPFC_SLI_ACTIVE;
case MBX_RESUME_RPI:
case MBX_READ_EVENT_LOG_STATUS:
case MBX_READ_EVENT_LOG:
+ case MBX_SECURITY_MGMT:
+ case MBX_AUTH_PORT:
ret = mbxCommand;
break;
default:
pmb->context2 = NULL;
}
+ /* Check security permission status on INIT_LINK mailbox command */
+ if ((pmb->u.mb.mbxCommand == MBX_INIT_LINK) &&
+ (pmb->u.mb.mbxStatus == MBXERR_SEC_NO_PERMISSION))
+ lpfc_printf_log(phba, KERN_ERR, LOG_MBOX | LOG_SLI,
+ "2860 SLI authentication is required "
+ "for INIT_LINK but has not done yet\n");
+
if (bf_get(lpfc_mqe_command, &pmb->u.mqe) == MBX_SLI4_CONFIG)
lpfc_sli4_mbox_cmd_free(phba, pmb);
else
i = 0;
while ((status & (HS_FFRDY | HS_MBRDY)) != (HS_FFRDY | HS_MBRDY)) {
- /* Check every 100ms for 5 retries, then every 500ms for 5, then
- * every 2.5 sec for 5, then reset board and every 2.5 sec for
- * 4.
+ /* Check every 10ms for 10 retries, then every 100ms for 90
+ * retries, then every 1 sec for 50 retires for a total of
+ * ~60 seconds before reset the board again and check every
+ * 1 sec for 50 retries. The up to 60 seconds before the
+ * board ready is required by the Falcon FIPS zeroization
+ * complete, and any reset the board in between shall cause
+ * restart of zeroization, further delay the board ready.
*/
- if (i++ >= 20) {
+ if (i++ >= 200) {
/* Adapter failed to init, timeout, status reg
<status> */
lpfc_printf_log(phba, KERN_ERR, LOG_INIT,
return -EIO;
}
- if (i <= 5) {
+ if (i <= 10)
msleep(10);
- } else if (i <= 10) {
- msleep(500);
- } else {
- msleep(2500);
- }
+ else if (i <= 100)
+ msleep(100);
+ else
+ msleep(1000);
- if (i == 15) {
- /* Do post */
+ if (i == 150) {
+ /* Do post */
phba->pport->port_state = LPFC_VPORT_UNKNOWN;
lpfc_sli_brdrestart(phba);
}
uint8_t command_type = ELS_COMMAND_NON_FIP;
uint8_t cmnd;
uint16_t xritag;
+ uint16_t abrt_iotag;
+ struct lpfc_iocbq *abrtiocbq;
struct ulp_bde64 *bpl = NULL;
uint32_t els_id = ELS_ID_DEFAULT;
int numBdes, i;
case CMD_ABORT_XRI_CX:
/* words 0-2 memcpy should be 0 rserved */
/* port will send abts */
- if (iocbq->iocb.ulpCommand == CMD_CLOSE_XRI_CN)
+ abrt_iotag = iocbq->iocb.un.acxri.abortContextTag;
+ if (abrt_iotag != 0 && abrt_iotag <= phba->sli.last_iotag) {
+ abrtiocbq = phba->sli.iocbq_lookup[abrt_iotag];
+ fip = abrtiocbq->iocb_flag & LPFC_FIP_ELS_ID_MASK;
+ } else
+ fip = 0;
+
+ if ((iocbq->iocb.ulpCommand == CMD_CLOSE_XRI_CN) || fip)
/*
- * The link is down so the fw does not need to send abts
+ * The link is down, or the command was ELS_FIP
+ * so the fw does not need to send abts
* on the wire.
*/
bf_set(abort_cmd_ia, &wqe->abort_cmd, 1);
/* Check if there is a deferred error condition is active */
if ((HS_FFER1 & phba->work_hs) &&
((HS_FFER2 | HS_FFER3 | HS_FFER4 | HS_FFER5 |
- HS_FFER6 | HS_FFER7) & phba->work_hs)) {
+ HS_FFER6 | HS_FFER7 | HS_FFER8) & phba->work_hs)) {
phba->hba_flag |= DEFER_ERATT;
/* Clear all interrupt enable conditions */
writel(0, phba->HCregaddr);
*/
if ((HS_FFER1 & phba->work_hs) &&
((HS_FFER2 | HS_FFER3 | HS_FFER4 | HS_FFER5 |
- HS_FFER6 | HS_FFER7) & phba->work_hs)) {
+ HS_FFER6 | HS_FFER7 | HS_FFER8) &
+ phba->work_hs)) {
phba->hba_flag |= DEFER_ERATT;
/* Clear all interrupt enable conditions */
writel(0, phba->HCregaddr);
OSDN Git Service
