hw/misc/tmp105: reset the T_low and T_High registers

The TMP105 datasheet (https://www.ti.com/lit/gpn/tmp105) says that the
power-up reset values for the T_low and T_high registers are 80 degrees C
and 75 degrees C, which are 0x500 and 0x4B0 hex according to table 5.  These
values are then shifted right by four bits to give the register reset
values, since both registers store the 12 bits of temperature data in bits
[15..4] of a 16 bit register.

We were resetting these registers to zero, which is problematic for Linux
guests which enable the alert interrupt and then immediately take an
unexpected overtemperature alert because the current temperature is above
freezing...

Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Cédric Le Goater <clg@kaod.org>
Message-id: 20201110150023.25533-2-peter.maydell@linaro.org

diff --git a/hw/misc/tmp105.c b/hw/misc/tmp105.c
index b471204..0a4aad4 100644 (file)
--- a/hw/misc/tmp105.c
+++ b/hw/misc/tmp105.c
@@ -225,6 +225,9 @@ static void tmp105_reset(I2CSlave *i2c)
     s->faults = tmp105_faultq[(s->config >> 3) & 3];
     s->alarm = 0;
 
+    s->limit[0] = 0x4b00; /* T_LOW, 75 degrees C */
+    s->limit[1] = 0x5000; /* T_HIGH, 80 degrees C */
+
     tmp105_interrupt_update(s);
 }