ath10k: Do not send probe response template for mesh

[ Upstream commit 97354f2c432788e3163134df6bb144f4b6289d87 ]

Currently mac80211 do not support probe response template for
mesh point. When WMI_SERVICE_BEACON_OFFLOAD is enabled, host
driver tries to configure probe response template for mesh, but
it fails because the interface type is not NL80211_IFTYPE_AP but
NL80211_IFTYPE_MESH_POINT.

To avoid this failure, skip sending probe response template to
firmware for mesh point.

Tested HW: WCN3990/QCA6174/QCA9984

Signed-off-by: Surabhi Vishnoi <svishnoi@codeaurora.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>

diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index fb632a4..1588fe8 100644 (file)
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -1596,6 +1596,10 @@ static int ath10k_mac_setup_prb_tmpl(struct ath10k_vif *arvif)
        if (arvif->vdev_type != WMI_VDEV_TYPE_AP)
                return 0;
 
+        /* For mesh, probe response and beacon share the same template */
+       if (ieee80211_vif_is_mesh(vif))
+               return 0;
+
        prb = ieee80211_proberesp_get(hw, vif);
        if (!prb) {
                ath10k_warn(ar, "failed to get probe resp template from mac80211\n");