From: Martin Blumenstingl Date: Fri, 25 Nov 2016 13:12:01 +0000 (+0100) Subject: net: phy: realtek: fix enabling of the TX-delay for RTL8211F X-Git-Tag: v4.9-rc8~5^2~49^2 X-Git-Url: http://git.osdn.net/view?a=commitdiff_plain;h=e3230494b57ece68750e3e32d3e53d6b00917058;p=uclinux-h8%2Flinux.git net: phy: realtek: fix enabling of the TX-delay for RTL8211F The old logic always enabled the TX-delay when the phy-mode was set to PHY_INTERFACE_MODE_RGMII. There are dedicated phy-modes which tell the PHY driver to enable the RX and/or TX delays: - PHY_INTERFACE_MODE_RGMII should disable the RX and TX delay in the PHY (if required, the MAC should add the delays in this case) - PHY_INTERFACE_MODE_RGMII_ID should enable RX and TX delay in the PHY - PHY_INTERFACE_MODE_RGMII_TXID should enable the TX delay in the PHY - PHY_INTERFACE_MODE_RGMII_RXID should enable the RX delay in the PHY (currently not supported by RTL8211F) With this patch we enable the TX delay for PHY_INTERFACE_MODE_RGMII_ID and PHY_INTERFACE_MODE_RGMII_TXID. Additionally we now explicity disable the TX-delay, which seems to be enabled automatically after a hard-reset of the PHY (by triggering it's reset pin) to get a consistent state (as defined by the phy-mode). This fixes a compatibility problem with some SoCs where the TX-delay was also added by the MAC. With the TX-delay being applied twice the TX clock was off and TX traffic was broken or very slow (<10Mbit/s) on 1000Mbit/s links. Signed-off-by: Martin Blumenstingl Reviewed-by: Florian Fainelli Signed-off-by: David S. Miller --- diff --git a/drivers/net/phy/realtek.c b/drivers/net/phy/realtek.c index aadd6e9f54ad..9cbe645e3d89 100644 --- a/drivers/net/phy/realtek.c +++ b/drivers/net/phy/realtek.c @@ -102,15 +102,19 @@ static int rtl8211f_config_init(struct phy_device *phydev) if (ret < 0) return ret; - if (phydev->interface == PHY_INTERFACE_MODE_RGMII) { - /* enable TXDLY */ - phy_write(phydev, RTL8211F_PAGE_SELECT, 0xd08); - reg = phy_read(phydev, 0x11); + phy_write(phydev, RTL8211F_PAGE_SELECT, 0xd08); + reg = phy_read(phydev, 0x11); + + /* enable TX-delay for rgmii-id and rgmii-txid, otherwise disable it */ + if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID || + phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID) reg |= RTL8211F_TX_DELAY; - phy_write(phydev, 0x11, reg); - /* restore to default page 0 */ - phy_write(phydev, RTL8211F_PAGE_SELECT, 0x0); - } + else + reg &= ~RTL8211F_TX_DELAY; + + phy_write(phydev, 0x11, reg); + /* restore to default page 0 */ + phy_write(phydev, RTL8211F_PAGE_SELECT, 0x0); return 0; }