From 08ed48e182ef870517a84d2331c4c5da8f1c3b3a Mon Sep 17 00:00:00 2001 From: Emil Tantilov Date: Wed, 17 May 2017 15:17:51 -0700 Subject: [PATCH] ixgbe: always call setup_mac_link for multispeed fiber Remove the logic which would previously skip the link configuration in the case where we are already at the requested speed in ixgbe_setup_mac_link_multispeed_fiber(). By exiting early we are skipping the link configuration and as such the driver may not always configure the PHY correctly for SFP+. Signed-off-by: Emil Tantilov Tested-by: Andrew Bowers Signed-off-by: Jeff Kirsher --- drivers/net/ethernet/intel/ixgbe/ixgbe_common.c | 18 ------------------ 1 file changed, 18 deletions(-) diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c index 76ad0e0bd542..7af85f505bad 100644 --- a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c +++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c @@ -4121,15 +4121,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct ixgbe_hw *hw, speedcnt++; highest_link_speed = IXGBE_LINK_SPEED_10GB_FULL; - /* If we already have link at this speed, just jump out */ - status = hw->mac.ops.check_link(hw, &link_speed, &link_up, - false); - if (status) - return status; - - if (link_speed == IXGBE_LINK_SPEED_10GB_FULL && link_up) - goto out; - /* Set the module link speed */ switch (hw->phy.media_type) { case ixgbe_media_type_fiber: @@ -4181,15 +4172,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct ixgbe_hw *hw, if (highest_link_speed == IXGBE_LINK_SPEED_UNKNOWN) highest_link_speed = IXGBE_LINK_SPEED_1GB_FULL; - /* If we already have link at this speed, just jump out */ - status = hw->mac.ops.check_link(hw, &link_speed, &link_up, - false); - if (status) - return status; - - if (link_speed == IXGBE_LINK_SPEED_1GB_FULL && link_up) - goto out; - /* Set the module link speed */ switch (hw->phy.media_type) { case ixgbe_media_type_fiber: -- 2.11.0