From 1cadfc5877f15a14a77f4161f3ce9f436a39116d Mon Sep 17 00:00:00 2001 From: Claire Chang Date: Wed, 19 Jun 2019 16:41:10 +0800 Subject: [PATCH] dt-bindings: serial: add documentation for Rx in-band wakeup support To support Rx in-band wakeup, one must create an interrupt specifier with edge sensitivity on Rx pin and an addtional pinctrl to reconfigure Rx pin to normal GPIO in sleep state. Driver will switch to sleep mode pinctrl and enable irq wake before suspend and restore to default settings when resuming. Signed-off-by: Claire Chang Signed-off-by: Rob Herring --- Documentation/devicetree/bindings/serial/mtk-uart.txt | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/serial/mtk-uart.txt b/Documentation/devicetree/bindings/serial/mtk-uart.txt index c6b5262eb352..6fdffb735fb9 100644 --- a/Documentation/devicetree/bindings/serial/mtk-uart.txt +++ b/Documentation/devicetree/bindings/serial/mtk-uart.txt @@ -23,7 +23,12 @@ Required properties: - reg: The base address of the UART register bank. -- interrupts: A single interrupt specifier. +- interrupts: + index 0: an interrupt specifier for the UART controller itself + index 1: optional, an interrupt specifier with edge sensitivity on Rx pin to + support Rx in-band wake up. If one would like to use this feature, + one must create an addtional pinctrl to reconfigure Rx pin to normal + GPIO before suspend. - clocks : Must contain an entry for each entry in clock-names. See ../clocks/clock-bindings.txt for details. @@ -39,7 +44,11 @@ Example: uart0: serial@11006000 { compatible = "mediatek,mt6589-uart", "mediatek,mt6577-uart"; reg = <0x11006000 0x400>; - interrupts = ; + interrupts = , + ; clocks = <&uart_clk>, <&bus_clk>; clock-names = "baud", "bus"; + pinctrl-names = "default", "sleep"; + pinctrl-0 = <&uart_pin>; + pinctrl-1 = <&uart_pin_sleep>; }; -- 2.11.0