From 2398391017ddec9427bdb94cc5d70326eaf8a3c5 Mon Sep 17 00:00:00 2001 From: Ian Abbott Date: Fri, 5 Jun 2015 18:30:14 +0100 Subject: [PATCH] staging: comedi: das08: rename and rewrite DAS08_IRQ The `DAS08_IRQ` macro contains a mask for the "IRQ" status bit. This is set to 1 when a rising edge is detected on the external interrupt input pin of the external connector (which may be jumpered to a pacer output). It is cleared by setting the "INTE" control bit to 0. It is not used on "JR" boards. Rename the macro to `DAS08_STATUS_IRQ` and add a comment. Also use the `BIT()` macro to define the value. Signed-off-by: Ian Abbott Reviewed-by: H Hartley Sweeten Signed-off-by: Greg Kroah-Hartman --- drivers/staging/comedi/drivers/das08.c | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-) diff --git a/drivers/staging/comedi/drivers/das08.c b/drivers/staging/comedi/drivers/das08.c index 04843080b5e8..935bbfb213e6 100644 --- a/drivers/staging/comedi/drivers/das08.c +++ b/drivers/staging/comedi/drivers/das08.c @@ -59,7 +59,12 @@ #define DAS08_AI_TRIG_REG 0x01 /* (W) AI software trigger */ #define DAS08_STATUS_REG 0x02 /* (R) status */ #define DAS08_STATUS_AI_BUSY BIT(7) /* AI conversion in progress */ -#define DAS08_IRQ (1<<3) +/* + * The IRQ status bit is set to 1 by a rising edge on the external interrupt + * input (which may be jumpered to the pacer output). It is cleared by + * setting the INTE control bit to 0. Not present on "JR" boards. + */ +#define DAS08_STATUS_IRQ BIT(3) /* latched interrupt input */ #define DAS08_IP(x) (((x)>>4)&0x7) #define DAS08_CONTROL 2 #define DAS08_MUX_MASK 0x7 -- 2.11.0