From 2ecb287998a47cc0a766f6071f63bc185f338540 Mon Sep 17 00:00:00 2001 From: afzal mohammed Date: Mon, 21 Oct 2019 06:06:14 +0100 Subject: [PATCH] ARM: 8926/1: v7m: remove register save to stack before svc r0-r3 & r12 registers are saved & restored, before & after svc respectively. Intention was to preserve those registers across thread to handler mode switch. On v7-M, hardware saves the register context upon exception in AAPCS complaint way. Restoring r0-r3 & r12 is done from stack location where hardware saves it, not from the location on stack where these registers were saved. To clarify, on stm32f429 discovery board: 1. before svc, sp - 0x90009ff8 2. r0-r3,r12 saved to 0x90009ff8 - 0x9000a00b 3. upon svc, h/w decrements sp by 32 & pushes registers onto stack 4. after svc, sp - 0x90009fd8 5. r0-r3,r12 restored from 0x90009fd8 - 0x90009feb Above means r0-r3,r12 is not restored from the location where they are saved, but since hardware pushes the registers onto stack, the registers are restored correctly. Note that during register saving to stack (step 2), it goes past 0x9000a000. And it seems, based on objdump, there are global symbols residing there, and it perhaps can cause issues on a non-XIP Kernel (on XIP, data section is setup later). Based on the analysis above, manually saving registers onto stack is at best no-op and at worst can cause data section corruption. Hence remove storing of registers onto stack before svc. Fixes: b70cd406d7fe ("ARM: 8671/1: V7M: Preserve registers across switch from Thread to Handler mode") Signed-off-by: afzal mohammed Acked-by: Vladimir Murzin Signed-off-by: Russell King --- arch/arm/mm/proc-v7m.S | 1 - 1 file changed, 1 deletion(-) diff --git a/arch/arm/mm/proc-v7m.S b/arch/arm/mm/proc-v7m.S index efebf4120a0c..1a49d503eafc 100644 --- a/arch/arm/mm/proc-v7m.S +++ b/arch/arm/mm/proc-v7m.S @@ -132,7 +132,6 @@ __v7m_setup_cont: dsb mov r6, lr @ save LR ldr sp, =init_thread_union + THREAD_START_SP - stmia sp, {r0-r3, r12} cpsie i svc #0 1: cpsid i -- 2.11.0