From 5b7d414ad025654516c59efd16b4a7f0d8017c1b Mon Sep 17 00:00:00 2001 From: Gregory Fong Date: Wed, 6 May 2015 01:37:55 -0700 Subject: [PATCH] dt-bindings: add brcmstb-gpio GPIO binding Add binding for Broadcom STB "UPG GIO" GPIO controller. Signed-off-by: Gregory Fong Signed-off-by: Linus Walleij --- .../devicetree/bindings/gpio/brcm,brcmstb-gpio.txt | 65 ++++++++++++++++++++++ 1 file changed, 65 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/brcm,brcmstb-gpio.txt diff --git a/Documentation/devicetree/bindings/gpio/brcm,brcmstb-gpio.txt b/Documentation/devicetree/bindings/gpio/brcm,brcmstb-gpio.txt new file mode 100644 index 000000000000..435f1bcca341 --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/brcm,brcmstb-gpio.txt @@ -0,0 +1,65 @@ +Broadcom STB "UPG GIO" GPIO controller + +The controller's registers are organized as sets of eight 32-bit +registers with each set controlling a bank of up to 32 pins. A single +interrupt is shared for all of the banks handled by the controller. + +Required properties: + +- compatible: + Must be "brcm,brcmstb-gpio" + +- reg: + Define the base and range of the I/O address space containing + the brcmstb GPIO controller registers + +- #gpio-cells: + Should be <2>. The first cell is the pin number (within the controller's + pin space), and the second is used for the following: + bit[0]: polarity (0 for active-high, 1 for active-low) + +- gpio-controller: + Specifies that the node is a GPIO controller. + +- brcm,gpio-bank-widths: + Number of GPIO lines for each bank. Number of elements must + correspond to number of banks suggested by the 'reg' property. + +Optional properties: + +- interrupts: + The interrupt shared by all GPIO lines for this controller. + +- interrupt-parent: + phandle of the parent interrupt controller + +- #interrupt-cells: + Should be <2>. The first cell is the GPIO number, the second should specify + flags. The following subset of flags is supported: + - bits[3:0] trigger type and level flags + 1 = low-to-high edge triggered + 2 = high-to-low edge triggered + 4 = active high level-sensitive + 8 = active low level-sensitive + Valid combinations are 1, 2, 3, 4, 8. + See also Documentation/devicetree/bindings/interrupt-controller/interrupts.txt + +- interrupt-controller: + Marks the device node as an interrupt controller + +- interrupt-names: + The name of the IRQ resource used by this controller + +Example: + upg_gio: gpio@f040a700 { + #gpio-cells = <0x2>; + #interrupt-cells = <0x2>; + compatible = "brcm,bcm7445-gpio", "brcm,brcmstb-gpio"; + gpio-controller; + interrupt-controller; + reg = <0xf040a700 0x80>; + interrupt-parent = <0xf>; + interrupts = <0x6>; + interrupt-names = "upg_gio"; + brcm,gpio-bank-widths = <0x20 0x20 0x20 0x18>; + }; -- 2.11.0