From 78060d51950d242a3e20941b1280fcc76850634c Mon Sep 17 00:00:00 2001 From: Markus Pargmann Date: Mon, 14 Dec 2015 12:41:52 -0200 Subject: [PATCH] [media] v4l: mt9v032: Do not unset master_mode The power_on function of the driver resets the chip and sets the CHIP_CONTROL register to 0. This switches the operating mode to slave. The s_stream function sets the correct mode. But this caused problems on a board where the camera chip is operated as master. The camera started after a random amount of time streaming an image, I observed between 10 and 300 seconds. The STRFM_OUT and STLN_OUT pins are not connected on this board which may cause some issues in slave mode. I could not find any documentation about this. Keeping the chip in master mode after the reset helped to fix this issue for me. Signed-off-by: Markus Pargmann Signed-off-by: Laurent Pinchart Signed-off-by: Mauro Carvalho Chehab --- drivers/media/i2c/mt9v032.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/media/i2c/mt9v032.c b/drivers/media/i2c/mt9v032.c index e47fe4041034..4a5e0e5f4941 100644 --- a/drivers/media/i2c/mt9v032.c +++ b/drivers/media/i2c/mt9v032.c @@ -348,7 +348,8 @@ static int mt9v032_power_on(struct mt9v032 *mt9v032) if (ret < 0) return ret; - return regmap_write(map, MT9V032_CHIP_CONTROL, 0); + return regmap_write(map, MT9V032_CHIP_CONTROL, + MT9V032_CHIP_CONTROL_MASTER_MODE); } static void mt9v032_power_off(struct mt9v032 *mt9v032) @@ -420,8 +421,7 @@ __mt9v032_get_pad_crop(struct mt9v032 *mt9v032, struct v4l2_subdev_pad_config *c static int mt9v032_s_stream(struct v4l2_subdev *subdev, int enable) { - const u16 mode = MT9V032_CHIP_CONTROL_MASTER_MODE - | MT9V032_CHIP_CONTROL_DOUT_ENABLE + const u16 mode = MT9V032_CHIP_CONTROL_DOUT_ENABLE | MT9V032_CHIP_CONTROL_SEQUENTIAL; struct mt9v032 *mt9v032 = to_mt9v032(subdev); struct v4l2_rect *crop = &mt9v032->crop; -- 2.11.0