From b509c02d0f31639dda90f9b7269668b86c9b25ef Mon Sep 17 00:00:00 2001 From: Loic Poulain Date: Wed, 8 Oct 2014 16:54:28 +0200 Subject: [PATCH] Bluetooth: HCI H5 peer reset detection H5 Specification says: If a SYNC message is received while in the Active State, it is assumed that the peer device has reset. The local device should therefore perform a full reset of the upper stack, and start Link Establishment again at the Uninitialized State. Upon entering the Active State, the first packet sent shall have its SEQ and ACK numbers set to zero. This patch resets the HCI H5 driver data/state to unitialized and reports an HCI hardware error event to notify the upper stack that HCI synchronization has been lost. H5 will be re-synchronized and upper stack should generate an HCI Reset command. Signed-off-by: Loic Poulain Signed-off-by: Johan Hedberg --- drivers/bluetooth/hci_h5.c | 34 ++++++++++++++++++++++++++++++++++ 1 file changed, 34 insertions(+) diff --git a/drivers/bluetooth/hci_h5.c b/drivers/bluetooth/hci_h5.c index a22838669b4e..20bdd71559b1 100644 --- a/drivers/bluetooth/hci_h5.c +++ b/drivers/bluetooth/hci_h5.c @@ -168,6 +168,36 @@ wakeup: hci_uart_tx_wakeup(hu); } +static void h5_peer_reset(struct hci_uart *hu) +{ + struct h5 *h5 = hu->priv; + struct sk_buff *skb; + const unsigned char hard_err[] = { 0x10, 0x01, 0x00 }; + + BT_ERR("Peer device has reset"); + + h5->state = H5_UNINITIALIZED; + + del_timer(&h5->timer); + + skb_queue_purge(&h5->rel); + skb_queue_purge(&h5->unrel); + skb_queue_purge(&h5->unack); + + h5->tx_seq = 0; + h5->tx_ack = 0; + + skb = bt_skb_alloc(3, GFP_ATOMIC); + if (!skb) + return; + + bt_cb(skb)->pkt_type = HCI_EVENT_PKT; + memcpy(skb_put(skb, 3), hard_err, 3); + + /* Send Hardware Error to upper stack */ + hci_recv_frame(hu->hdev, skb); +} + static int h5_open(struct hci_uart *hu) { struct h5 *h5; @@ -283,8 +313,12 @@ static void h5_handle_internal_rx(struct hci_uart *hu) conf_req[2] = h5_cfg_field(h5); if (memcmp(data, sync_req, 2) == 0) { + if (h5->state == H5_ACTIVE) + h5_peer_reset(hu); h5_link_control(hu, sync_rsp, 2); } else if (memcmp(data, sync_rsp, 2) == 0) { + if (h5->state == H5_ACTIVE) + h5_peer_reset(hu); h5->state = H5_INITIALIZED; h5_link_control(hu, conf_req, 3); } else if (memcmp(data, conf_req, 2) == 0) { -- 2.11.0