apic_ap_setup();
/*
- * Need to setup vector mappings before we enable interrupts.
- */
- setup_vector_irq(smp_processor_id());
-
- /*
* Save our processor parameters. Note: this information
* is needed for clock calibration.
*/
check_tsc_sync_target();
/*
- * Enable the espfix hack for this CPU
- */
-#ifdef CONFIG_X86_ESPFIX64
- init_espfix_ap();
-#endif
-
- /*
- * We need to hold vector_lock so there the set of online cpus
- * does not change while we are assigning vectors to cpus. Holding
- * this lock ensures we don't half assign or remove an irq from a cpu.
+ * Lock vector_lock and initialize the vectors on this cpu
+ * before setting the cpu online. We must set it online with
+ * vector_lock held to prevent a concurrent setup/teardown
+ * from seeing a half valid vector space.
*/
lock_vector_lock();
+ setup_vector_irq(smp_processor_id());
set_cpu_online(smp_processor_id(), true);
unlock_vector_lock();
cpu_set_state_online(smp_processor_id());
initial_code = (unsigned long)start_secondary;
stack_start = idle->thread.sp;
+ /*
+ * Enable the espfix hack for this CPU
+ */
+#ifdef CONFIG_X86_ESPFIX64
+ init_espfix_ap(cpu);
+#endif
+
/* So we see what's up */
announce_cpu(cpu, apicid);