1 Motorola M5206eC3 Evaluation Board
2 ----------------------------------
4 uClinux/Coldfire is configured to use 4MB of RAM on the M5206eC3 board.
6 Both the linux-2.0.x and linux-2.4.x kernels are supported, and both the
7 uC-libc and uClibc libraries as well. (Note that glibc is *not* supported
10 The build process results in a file, images/image.bin, that can be loaded
11 into the M5206eC3 board using the builtin dBUG firmware.
13 To load using the ethernet network download:
17 To start up the image use:
21 The serial port console is configured to be the first ColdFire UART. On the
22 M5206eC3 board this is the same serial port that dBUG runs on. Its is the
23 port labeled "Terminal". uClinux/Coldfire configures this port for 19200
24 baud, 8 data bits, no parity, 1 stop bit. You should see the kernel boot
25 messages come out on this port, and uClinux/Coldfire will boot to an
26 interactive Linux shell.
28 You could also use the serial port download. The serial download is slow,
29 it will take several minutes to load the image. You must use an S-record
30 format binary when loading over the serial line. (You can use
31 m68k-elf-objcopy to convert the binary file to S-Record format.)