Arnewsh 5206 Evaluation Board ----------------------------- Most Arnewsh 5206 boards come equiped with 1MB of RAM as standard. The default configuration in uClinux-dist for this board will make an image small enough to run on this. Both the linux-2.0.x and linux-2.4.x kernels are supported, and both the uC-libc and uClibc libraries as well. (Note that glibc is *not* supported on this target). The build process results in a file, images/image.bin, that can be loaded into the A5206 board. To load using the ethernet network download: dn -i image.bin To start up the image use: go 0x10000 The serial port console is configured to be the first ColdFire UART. On the Arnewsh 5206 board this is the other serial port, not the port normally used for dBUG. uClinux/Coldfire will configure this port for 9600 baud, 8 data bits, no parity, 1 stop bit. You should see the kernel boot messages come out on this port, and uClinux/Coldfire will boot to an interactive Linux shell. You could also use the serial port download. The serial download is slow, it will take several minutes to load the image. You must use an S-record format binary when loading over the serial line. (You can use m68k-elf-objcopy to convert the binary file to S-Record format.)