Arnewsh 5307 Evaluation Board ----------------------------- The Arnewsh 5307 boards come equiped with 8MB of RAM as standard. The default configuration in uClinux-dist for this board assumes this much RAM, and cannot auto detect how much is present (due to the broken watchdog timer of the early mask 5307 silicon). Both the linux-2.0.x and linux-2.4.x kernels are supported, and both the uC-libc and uClibc libraries as well. (Note that glibc is *not* supported on this target). The build process results in a file, images/image.bin, that can be loaded into the A5307 board. To load using the ethernet network download: dn -i image.bin To start up the image use: go 0x20000 The serial port console is configured to be the first ColdFire UART. On the Arnewsh 5307 board this is the same serial port that dBUG runs on. Its is the port labeled "Terminal". uClinux/Coldfire configures this port for 19200 baud, 8 data bits, no parity, 1 stop bit. You should see the kernel boot messages come out on this port, and uClinux/Coldfire will boot to an interactive Linux shell. You could also use the serial port download. The serial download is slow, it will take several minutes to load the image. You must use an S-record format binary when loading over the serial line. (You can use m68k-elf-objcopy to convert the binary file to S-Record format.)