rtc: at91sam9: get sclk rate after enabling it

See help for clk_get_rate(): "obtain the current clock rate (in Hz) for a
clock source. This is only valid once the clock source has been enabled."

It currently returns the correct value but that may not stay that way.

Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>
Acked-by: Boris Brezillon <boris.brezillon@free-electrons.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>

diff --git a/drivers/rtc/rtc-at91sam9.c b/drivers/rtc/rtc-at91sam9.c
index 23f721d..f9e85ac 100644 (file)
--- a/drivers/rtc/rtc-at91sam9.c
+++ b/drivers/rtc/rtc-at91sam9.c
@@ -425,18 +425,19 @@ static int at91_rtc_probe(struct platform_device *pdev)
        if (IS_ERR(rtc->sclk))
                return PTR_ERR(rtc->sclk);
 
-       sclk_rate = clk_get_rate(rtc->sclk);
-       if (!sclk_rate || sclk_rate > AT91_RTT_RTPRES) {
-               dev_err(&pdev->dev, "Invalid slow clock rate\n");
-               return -EINVAL;
-       }
-
        ret = clk_prepare_enable(rtc->sclk);
        if (ret) {
                dev_err(&pdev->dev, "Could not enable slow clock\n");
                return ret;
        }
 
+       sclk_rate = clk_get_rate(rtc->sclk);
+       if (!sclk_rate || sclk_rate > AT91_RTT_RTPRES) {
+               dev_err(&pdev->dev, "Invalid slow clock rate\n");
+               ret = -EINVAL;
+               goto err_clk;
+       }
+
        mr = rtt_readl(rtc, MR);
 
        /* unless RTT is counting at 1 Hz, re-initialize it */