- interrupts: Should contain spi interrupt
- clocks: phandles to input clocks.
- The first should be <&topckgen CLK_TOP_SPI_SEL>.
- The second should be one of the following.
+ The first should be one of the following. It's PLL.
- <&clk26m>: specify parent clock 26MHZ.
- <&topckgen CLK_TOP_SYSPLL3_D2>: specify parent clock 109MHZ.
It's the default one.
- <&topckgen CLK_TOP_SYSPLL4_D2>: specify parent clock 78MHZ.
- <&topckgen CLK_TOP_UNIVPLL2_D4>: specify parent clock 104MHZ.
- <&topckgen CLK_TOP_UNIVPLL1_D8>: specify parent clock 78MHZ.
+ The second should be <&topckgen CLK_TOP_SPI_SEL>. It's clock mux.
+ The third is <&pericfg CLK_PERI_SPI0>. It's clock gate.
-- clock-names: shall be "spi-clk" for the controller clock, and
- "parent-clk" for the parent clock.
+- clock-names: shall be "parent-clk" for the parent clock, "sel-clk" for the
+ muxes clock, and "spi-clk" for the clock gate.
Optional properties:
- mediatek,pad-select: specify which pins group(ck/mi/mo/cs) spi
#size-cells = <0>;
reg = <0 0x1100a000 0 0x1000>;
interrupts = <GIC_SPI 110 IRQ_TYPE_LEVEL_LOW>;
- clocks = <&topckgen CLK_TOP_SPI_SEL>, <&topckgen CLK_TOP_SYSPLL3_D2>;
- clock-names = "spi-clk", "parent-clk";
+ clocks = <&topckgen CLK_TOP_SYSPLL3_D2>,
+ <&topckgen CLK_TOP_SPI_SEL>,
+ <&pericfg CLK_PERI_SPI0>;
+ clock-names = "parent-clk", "sel-clk", "spi-clk";
+
mediatek,pad-select = <0>;
status = "disabled";
};
return clk_prepare_enable(as->clk);
}
+#ifdef CONFIG_PM_SLEEP
static int atmel_spi_suspend(struct device *dev)
{
struct spi_master *master = dev_get_drvdata(dev);
return ret;
}
+#endif
static const struct dev_pm_ops atmel_spi_pm_ops = {
SET_SYSTEM_SLEEP_PM_OPS(atmel_spi_suspend, atmel_spi_resume)
/* otherwise we only allow transfers within the same page
* to avoid wasting time on dma_mapping when it is not practical
*/
- if (((size_t)tfr->tx_buf & PAGE_MASK) + tfr->len > PAGE_SIZE) {
+ if (((size_t)tfr->tx_buf & (PAGE_SIZE - 1)) + tfr->len > PAGE_SIZE) {
dev_warn_once(&spi->dev,
"Unaligned spi tx-transfer bridging page\n");
return false;
}
- if (((size_t)tfr->rx_buf & PAGE_MASK) + tfr->len > PAGE_SIZE) {
+ if (((size_t)tfr->rx_buf & (PAGE_SIZE - 1)) + tfr->len > PAGE_SIZE) {
dev_warn_once(&spi->dev,
- "Unaligned spi tx-transfer bridging page\n");
+ "Unaligned spi rx-transfer bridging page\n");
return false;
}
{ .compatible = "amlogic,meson6-spifc", },
{ },
};
+MODULE_DEVICE_TABLE(of, meson_spifc_dt_match);
static struct platform_driver meson_spifc_driver = {
.probe = meson_spifc_probe,
void __iomem *base;
u32 state;
u32 pad_sel;
- struct clk *spi_clk, *parent_clk;
+ struct clk *parent_clk, *sel_clk, *spi_clk;
struct spi_transfer *cur_transfer;
u32 xfer_len;
struct scatterlist *tx_sgl, *rx_sgl;
writel(mdata->pad_sel, mdata->base + SPI_PAD_SEL_REG);
}
-static int mtk_spi_prepare_hardware(struct spi_master *master)
-{
- struct spi_transfer *trans;
- struct mtk_spi *mdata = spi_master_get_devdata(master);
- struct spi_message *msg = master->cur_msg;
-
- trans = list_first_entry(&msg->transfers, struct spi_transfer,
- transfer_list);
- if (!trans->cs_change) {
- mdata->state = MTK_SPI_IDLE;
- mtk_spi_reset(mdata);
- }
-
- return 0;
-}
-
static int mtk_spi_prepare_message(struct spi_master *master,
struct spi_message *msg)
{
struct mtk_spi *mdata = spi_master_get_devdata(spi->master);
reg_val = readl(mdata->base + SPI_CMD_REG);
- if (!enable)
+ if (!enable) {
reg_val |= SPI_CMD_PAUSE_EN;
- else
+ writel(reg_val, mdata->base + SPI_CMD_REG);
+ } else {
reg_val &= ~SPI_CMD_PAUSE_EN;
- writel(reg_val, mdata->base + SPI_CMD_REG);
+ writel(reg_val, mdata->base + SPI_CMD_REG);
+ mdata->state = MTK_SPI_IDLE;
+ mtk_spi_reset(mdata);
+ }
}
static void mtk_spi_prepare_transfer(struct spi_master *master,
master->mode_bits = SPI_CPOL | SPI_CPHA;
master->set_cs = mtk_spi_set_cs;
- master->prepare_transfer_hardware = mtk_spi_prepare_hardware;
master->prepare_message = mtk_spi_prepare_message;
master->transfer_one = mtk_spi_transfer_one;
master->can_dma = mtk_spi_can_dma;
goto err_put_master;
}
- mdata->spi_clk = devm_clk_get(&pdev->dev, "spi-clk");
- if (IS_ERR(mdata->spi_clk)) {
- ret = PTR_ERR(mdata->spi_clk);
- dev_err(&pdev->dev, "failed to get spi-clk: %d\n", ret);
- goto err_put_master;
- }
-
mdata->parent_clk = devm_clk_get(&pdev->dev, "parent-clk");
if (IS_ERR(mdata->parent_clk)) {
ret = PTR_ERR(mdata->parent_clk);
goto err_put_master;
}
+ mdata->sel_clk = devm_clk_get(&pdev->dev, "sel-clk");
+ if (IS_ERR(mdata->sel_clk)) {
+ ret = PTR_ERR(mdata->sel_clk);
+ dev_err(&pdev->dev, "failed to get sel-clk: %d\n", ret);
+ goto err_put_master;
+ }
+
+ mdata->spi_clk = devm_clk_get(&pdev->dev, "spi-clk");
+ if (IS_ERR(mdata->spi_clk)) {
+ ret = PTR_ERR(mdata->spi_clk);
+ dev_err(&pdev->dev, "failed to get spi-clk: %d\n", ret);
+ goto err_put_master;
+ }
+
ret = clk_prepare_enable(mdata->spi_clk);
if (ret < 0) {
dev_err(&pdev->dev, "failed to enable spi_clk (%d)\n", ret);
goto err_put_master;
}
- ret = clk_set_parent(mdata->spi_clk, mdata->parent_clk);
+ ret = clk_set_parent(mdata->sel_clk, mdata->parent_clk);
if (ret < 0) {
dev_err(&pdev->dev, "failed to clk_set_parent (%d)\n", ret);
goto err_disable_clk;
pm_runtime_disable(&pdev->dev);
mtk_spi_reset(mdata);
- clk_disable_unprepare(mdata->spi_clk);
spi_master_put(master);
return 0;
if (!(sccr1_reg & SSCR1_TIE))
mask &= ~SSSR_TFS;
+ /* Ignore RX timeout interrupt if it is disabled */
+ if (!(sccr1_reg & SSCR1_TINTE))
+ mask &= ~SSSR_TINT;
+
if (!(status & mask))
return IRQ_NONE;
static inline void xtfpga_spi_write32(const struct xtfpga_spi *spi,
unsigned addr, u32 val)
{
- iowrite32(val, spi->regs + addr);
+ __raw_writel(val, spi->regs + addr);
}
static inline unsigned int xtfpga_spi_read32(const struct xtfpga_spi *spi,
unsigned addr)
{
- return ioread32(spi->regs + addr);
+ return __raw_readl(spi->regs + addr);
}
static inline void xtfpga_spi_wait_busy(struct xtfpga_spi *xspi)
*
* The caller is responsible for assigning the bus number and initializing
* the master's methods before calling spi_register_master(); and (after errors
- * adding the device) calling spi_master_put() and kfree() to prevent a memory
- * leak.
+ * adding the device) calling spi_master_put() to prevent a memory leak.
*/
struct spi_master *spi_alloc_master(struct device *dev, unsigned size)
{
kfree(spidev->rx_buffer);
spidev->rx_buffer = NULL;
- spidev->speed_hz = spidev->spi->max_speed_hz;
+ if (spidev->spi)
+ spidev->speed_hz = spidev->spi->max_speed_hz;
/* ... after we unbound from the underlying device? */
spin_lock_irq(&spidev->spi_lock);
/**
* struct spi_statistics - statistics for spi transfers
- * @clock: lock protecting this structure
+ * @lock: lock protecting this structure
*
* @messages: number of spi-messages handled
* @transfers: number of spi_transfers handled
OSDN Git Service
